Find experienced local carpenters in Maroubra South

We have side passage from the garage to the backyard. It's rarely used and not seen by guests but it is sinking away and needs replacing. It is approximately 4-5 metres in length

Hi there, We're looking for an experienced carpenter, joiner, or skilled handyman to supply and install a custom-sized door to close off our attic office space. The key challenge is that the door needs to be cut to fit neatly against an angled ceiling. The room is air-conditioned, so creating an effective seal is a top priority. Project Requirements & Specifications: • The Goal: Supply and install a finished door that seals an attic room. We are open to your professional recommendation on the best mechanism (e.g., a standard hinged door or a sliding door solution). • The Opening: The door will fit a non-standard, angled opening. • Dimensions: • Width: 655 mm (0.655 m) • Height (Low Side): 1630 mm (1.63 m) • Height (High Side): 1970 mm (1.97 m) • Angle: The top edge has an approximate 30-degree angle. • Door Panel: • Material: 25 mm thick white melamine panel (or a similar durable, pre-finished alternative). • Finishing: Must be professionally edged on all sides for a clean finish. • Key Feature: The installed door must provide a good seal around the frame to prevent air leakage from our air conditioning system. What your quote should include: • Supply of the custom-cut and edged door panel. • All required hardware (hinges, handle, track, etc.). • Any necessary door jambs, frames, or draft seals for a professional installation. • Full installation labour. • Site clean-up upon completion. Please see the attached photos to get a clear idea of the space. We are available for a site inspection for you to take precise measurements. We look forward to seeing your offers

Built in cabinet with two doors from floor to ceiling, three shelve needed. It will sit over a stairwell box. The frame will need to hold the majority of weight as the currents structure there is not strong. About 2.5 height, 950 depth and 900 width.

Need a carpenter to build a bunk bed similar to one we saw whilst on holiday. We want a double top bunk shelf and then a lower bunk & open space. Photos show a similar design for upper deck. Wall space 2950h 4220w Can explain more when selected. - Full wall length top bunk shelf. - Lower left hand side bed - lower right hand side enclave Assume struts hold up the top bunk shelf, and ladder can be fixed into this. Happy to take on expertise & feedback for best solution.

Carpenter or Cabinet maker to build under stairs storage cabinet

I would like to fix up the three cabinet doors in the photo. Was hoping to replace but I cannot find the same doors. It doesn’t have to be perfect but just better than the current look. Unsure if anything can be done but very open to suggestions

Assembling cabinets which are cut, edged and labelled in trolley ready to be assembled at our rockdale factory.

Need shelves / bench top and base open shelves to fill L shaped pantry. 2 parts: 1. Laminate shelves built - approx 2.1m tall x 200mm deep 2. Bench top 400mm wide x 1.8m long with open shelving underneath Installation must be included please. Looking for someone asap.

We need to purchase, transport and install the following things to our kitchen wall: Base cabinet: https://www.bunnings.com.au/practa-1000mm-melamine-practa-base-cabinet_p2663665 Wall cabinets: 2 x https://www.bunnings.com.au/kaboodle-800mm-wall-cabinet_p2662263 Bench top: https://www.bunnings.com.au/kaboodle-2400-x-600-x-38mm-black-granite-benchtop_p0194532 - Due date: Before Friday, 24th Dec 2021

Removing remaining parts of Kitchen including bench top, cabinets, cook top, sink. Must be taken away. Not left on site - Due date: Needs to be done on Monday, 6th Dec 2021