Find experienced local carpenters in Keilor

Install frame, door and cladding to close off underside of deck which is currently exposed. I’m showing day rate 7-3pm approx. i will supply materials.more images to follow, your welcome to come check the job .

Need a custom stainless steel bbq hot plate made 440 x 435….to look similar to attached

Build solid timber table like the picture, or even just the legs. Length of table 3.0 metres , width 1.2 metres height .720 metres. Out of solid dark oak.

New stairs installed. Need the stairs sanded and stained. Will include also the under part of the stairs. Will supply paint based on your recommendation. Need to have experience. Will require work to be done in the next week or so. Can discuss further. Painting of balustrades not included.

Looking for some shelving to be done around the house

I have a timber outdoor table and 2 bench seats that need to be resealed/stained. The table measures approx 3.3m x 1.3m. Bench seats are similar in length and approx 0.4m wide. Image attached. Picture of product to use also attached - Due date: Flexible

One shelf needs to be fitted to the pantry, please refer to photo. A couple of shelving to be added to the linen cupboard as there are none in there and we need storage space, please also refer to photo. The sooner this could be done, the better please. - Due date: Needs to be done on Friday, 1 September 2023

3 remote controlled wooden garage doors at the front of our property in need of sanding painting staining to get them back to pristine condition. One of them accidentally had a water jet blaster spray on to it and it removed a coat of paint from a section of it - Due date: Flexible

Seeking an AirTasker with experience cutting and fitting a timber benchtop. I have a Vic Ash utility benchtop panel (3600 x 600 x 33). We have a small kitchenette with four base cabinets (already assembled - 2600 total width). Benchtop to be installed flush against the wall on top these, and then run another 900 off the side of last cabinet to make a breakfast bar. The total benchtop area is about 3500 x 470, so you will need to trim the panel. The 130 offcut will run along the wall at the join of the benchtop to the wall as a small splash back, so cuts need to be good! I’ve got another similar sized Vic ash panel which will then need approx 840 x 470 cut off to form the side panel of the breakfast bar (running from the end of the beach top to the ground - and helping support the breakfast bar). Benchtop also will need a sink hole cut in - dimensions to be supplied for a sink that will top mount. Please include in offer: trimming/cutting of panels, mounting benchtop onto cabinets, and attaching benchtop end to support panel @ right angle. Hope that all makes sense. Any questions - please feel free to ask. Cheers. Install - Due date: Needs to be done on Friday, February 17, 2023