Find skilled builders in Ashwood

Looking for an experienced fabricator / welder / gate specialist to increase the height of my existing front driveway gate. The gate is a motorised double swing gate with vertical slats (powder-coated black). I want to raise the height so it sits just below the hedge line for added security. Scope of work: • Supply and install a top extension to the existing gate • Match the existing vertical slat design and spacing • Ensure the extension is structurally secure and aligned • Maintain smooth operation of the existing motorised swing mechanism • Finish to match existing (black powder-coated look) Please include: • Photos of similar work (if available) • Your recommended approach Happy to discuss ideas, just want the cleanest and most cost-effective solution. Photo 2 is existing and Photo 1 is proposed.

Hello, need someone to put an Easyshed together, thanks!

Looking for an experienced concreter to repair damaged concrete at the front of my property as required by the City of Monash council. Work required: - Repair 3 footpath slabs (bays 3, 4 and 5) - Bay 3 is part of the driveway crossover - Repair the right panel of the driveway crossover infill section - Remove damaged concrete and pour new concrete to match the existing Council requirements: Work must comply with the City of Monash standards Vehicle Crossing Permit and Traffic Management Plan may be required Pre-pour inspection by council required Looking for someone who: Has experience with council crossover/footpath works Can complete the job properly to pass the council inspection Location: Ashwood Please provide a quote including labour, materials, disposal of any waste and estimated timeframe

3x0.78x1.82m shed install https://easyshed.com.au/products/flat-roof-garden-shed-3m-w-x-0-78m-d-classic?variant=44452580589727

3x0.78x1.82m shed install https://easyshed.com.au/products/flat-roof-garden-shed-3m-w-x-0-78m-d-classic?variant=44452580589727

MAKE AN OFFER AND I AM READY TO DISCUSS. There are three tasks to be performed: A. Front fence - Plese see the attched the photo of similar fromt fence I want. -Brick part of the fence to be rendered as seen in the photo. - Fence height to be standard ( Approximaely 1.2M) B. Driveway automatic gate - The gate to be able to be opened or closed from the car while driving towards the house. C. Colorbond boundary fence on one side - Install colorbond boundary fence only on one side of the block. - Approximate length is 42M - Fence height; 1.8M -Install Colorbond lattice colorbond fence extender at the sections of the boundary fences as highlighted in the attached site plan. - Colorbond fence on either side of the house as shaded red in teh attched photo. It will be cool if one contractor can all these done.

Need an Easyshed installed on a concrete floor. Shed dimensions are: 2.25mW X 3.00mD X 2.4mH - includes 2 X Concrete fixing sets (8 per pack)

Demolition of an existing dwelling in Ashwood (removal of all trees, main dwelling, granny studio at rear and garage) along with any permits etc required. - Due date: Flexible

Install a garden shed on existing concrete flooring. Shed size 1.5 m × 0.78 m x 1.95 m. I will provide the shed and installation kit. You need to bring in all other required tools. You must have experience in installing sheds.

Pressure clean driveway as seen in photo down to the white garage door. - Due date: Flexible

Hi, I need someone to cut and remove 2 small portions of concrete on the driveway to allow electrician to complete underground electrical work. The first portion is about 1.7m by 0.5m and the second portion is about 2.6 by 0.4m. Please refer to pictures for marked area. Happy for a quote concrete cut and removal and disposal and would prefer for this job done as early as possible. - Due date: Before Saturday, 26 November 2022

Need a draftsman to help apply building permit which includes draft up for decking extension with cover