Find trusted awning repair experts in Sydney Eastern Suburbs

Hi there, I need someone to remove an old real estate signboard (wooden frame) that’s fixed to the awning above my shop in Bondi. You’ll need a long ladder and possibly a drill or tools to unscrew it. Once removed, please take the board away (dispose or recycle). Job should only take around 20–30 minutes. Flexible with timing — prefer sooner rather than later.

We recently have had new timber awnings put on the exterior of our house. Which need painting today or tomorrow. We have all the paint and painting equipment and ladders. The awnings required two coats of paint. I believe this is a 4 hour job. The cost showed here is for 4hours of work at $75 an hour. Can you please respond with your availability today and tomorrow to complete the work. Images are attached. Thank you for your time.

Hi there, We had a new sign installed recently and need to paint over where the previous sign hung from. Please see in images.

Complete short term repair to wood lattice awning at height, reattach and replace a few slats, sand and oil. I have replacement slats sander etc. Expect a few hours work. Lattice is above awning so access needs to be from top of awning, I have large plywood sheets to work from.

Need a handyperson to install glass and metal awning above back door. See photos of awning and door. New in box. Wall is rendered brick.

Need supply and install of replacement awnings. Will need to come out to measure and quote.

Replace damaged heavy duty awning zipper that is approximately 3m in length

Hi I need help installing my 270 degree CLEVERSHADE awning on my Mitsubishi Delica. Three L brackets. Hoping someone has done this before, it’s just too heavy on my own. One bracket will fit underneath the solar blanket. Happy to assist in installation. Weight of awning 25kgs.

steel has come away from arched end of plastic/perspex pergola

The hook on the awning has snapped and we can no longer use it. We have a part to replace it but we have no tools or ladder to reach the awning to replace the broken part. This job should not take long with the correct tools.

The old awning flew away due to wind. I've purchased a new like-for-like awning. It needs to be installed and screwed into the wall. The wall is a hollow wall, and the previous installer used a sort of filler expansion hard-setting foam to secure the bolt to the wall. This requires a special tool and a special building-grade filler. A successful job will be awarded to quality workmanship who can prevent future wind support issues and deterioration to the wall with no leaks. Existing awnings and supports have been removed, which is not in the photos. Works needs to remove all debris and scraps off site. When do you want to start? I'm flexible on start dates What is the status of your job? Ready to hire What type of service do you require? Replace existing awning What type of awning? Fixed Do you require supply and install? Install Only

Scrap back and clean awning prime and paint with exterior paint X 2 Also scrap back and paint side of awning and paint.

Need a painter to fix paint signage on a shop / cafe awning. Bondi2026 sign needs to be painted black. The Up South logo needs fresh white paint Previous Airtasker did not show up so need this done ASAP!

Our awning was ripped down by some pedestrians. Needs to be re-installed.

Window awning no longer winds in and out properly when using the winch box . Need to physical pull it down. On a 2nd floor window

Awning is on second level of semi. Was retracted during windy weather and is stuck in corner capping. Will need ladder and pole - 15 minute job.

We have a broken outdoor awning part that needs replacing. This part retracts the awning in and out

Underside of shopfront awning needs replacement, preferably with white aluminium panels. Old ceiling removed and disposed of. Approx 5 x 2.5 metres. Tested negative for asbestos. Requires council application for pavement closure.

We have a small open veranda balcony, internal is 2.5 by 2.7 meters approx, and need to install a cover on it. It’s on the third floor but there’s a roof and shouldn’t require scaffolding.

I need my shop front awnings painted white . The awning is polycarbonate and the frame is plastic