Find a reliable appliance technician in St Marys NSW

I need my Washer and Dryer Fixed

Need to install rangehood in the kitchen width is 600 mm, need to make hole in the roof.

My LG refrigerator stopped cooling and freezing . First the freezer stopped freezing and now the actual fridge stopped cooling

LG refrigerator stopped cooling from last few days . First the freezer stopped cooling and then in 2 days the fridge stopped cooling .

E32D4: Requires 230–240V, 27A single-phase power and does not come with a plug or cordset. It’s intended to be hardwired by an electrician (or connected via an appropriate isolator), not plugged into a 15A socket.

My new Hisense washing machine is displaying an F01 error code and is leaking water whenever I try to use it. I’m looking for someone experienced with washing machine repairs to diagnose and fix the issue as soon as possible.

The bolt for a gas strut on a treatment table has come loose and fallen out. The gas strut needs to be put back into place and bolt tightened.

Both my GHD Platinum+ and GHD Max straighteners are flashing red and no longer heat up. The warranties have expired. Could you please advise whether these models are repairable and provide an estimate for diagnosis or repair?

check existing gas lines and gas heater for any leaks, i want to ensure its safe to use throughout winter.

My fridge isnt cooling up to mark, maybe it needs a gas refilled or something

Need a freezer door seal installed on a double door fridge/freezer i have purchased the new seal just need it installed

Changing my stove correctly. I have the new stove for a few years and lost all the factory screw. Thank you

My washing machine spins and refills I think it has something to do with the drainage that needs checking or maybe blocked

Constant noisy fridge. Noise stops when fridge is opened. Has been defrosted but noise got worse and now fridge isn’t cooling as good as it was. Still freezes though. Hoping it’s a simple fix. No call out fee??? Hoping someone can help solve the noise problem.

Dismantling of an Amada ac2510 turret punch to fit on a standard float

Bought a new cooking range and it requires installation. It is 90 cm westinghouse freestanding one.

Drainage problem. Turns on but error E10 comes on when running. It’s a Siemens.

The roller shutter only works via remote control, i want it to have a manual override in case power outage

My Cricut machine won’t turn on only shows a red light on the power button. I’ve tried a new cord, have tried to update firmware/software but it doesn’t allow me too. Not sure if it’s fixable.

Rangehood is installed in kitchen, need to install duct to take the smoke out of the house. Scope of work (see image): a. drill a hole in the double brick wall for vent b. add a fly mesh or insect blocker on the outer side of the wall where the hole was made c. cut out part of wooden cabinetry above the rangehood to allow vent from the top of the rangehood d. add a venting pipe connecting the rangehood top to the wall, so smoke can be discharged out of the house