Find a reliable appliance technician in Rouse Hill

We need our washing machine installed. We had issues unscrewing the cold tap need someone who is experienced.

A heavy mirror has landed on my fitting coming from the wall gas outlet. Pushed down the fitting and damaged the drywall. No gas leak just need someone to fix the wall and outlet and ill re paint it.

We have a Matador outdoor BBQ unit and require the following parts to be removed and replaced with the new parts:- 4x Cast Iron Burner Tube 2x Flame Tamer 1x Grease Tray 1x Fire box rear panel 2x Grill plates Hoping someone can come and do this job for us. We've been told a handyman can do it and have been provided instructions from the manufacturer

The Rangewood needs motor to be removed and cleaned as it seems to be blocked .the filter is fine .

The dishwasher that came with the brand new kitchen is the right height and width and dips and I believe consistent water connections but the PowerPoint leads to be updated as the new dishwasher has an electrical plug with a larger ground terminal. I do not know what the budget should be so please let me know

Washing machine leaking. The interface is saying “no water” but it is just leaking. Would like to have it checked and repaired. Thank you

Attend site and assess the required works. Cut the gyprock behind gas bayonnet to expose gas pipework. Cut a tee into the existing gas line and run a new piece of copper pipe to where the gas cooktop will go. Test for leaks. Test completed works for correct operation where applicable. Clean work area and remove plumbing waste from site.

Description: ​Looking for a fully licensed gas fitter to extend a natural gas line for a new freestanding cooker in Rouse Hill. ​Job Details: ​Scope: Extend the existing gas line (coming out of the wall on the right) using surface-mounted copper piping. ​Route: Run copper pipe down the wall to near floor/foot level, then horizontally underneath the unit over to the bottom-left inlet connection point. Total distance is approx. 1.5 metres. ​Requirements: ​Must supply all copper piping, brass fittings, and connection components. ​Must perform pressure testing, check for leaks, and connect the cooker. ​Must provide a NSW Gas Compliance Certificate (CCLI) upon completion. ​Licensed gas fitters only please. ​Photos of the current wall outlet and freestanding cooker setup are attached for reference.

Auto pitcher filler not working. Tried cleaning and drying and resetting. Samsung fridge model no. SRF7500SB. Rouse Hill 2155.

Disconnect and install new 60cm cooktop

Hi, I need a licensed plumber/gasfitter to disconnect an existing gas oven and safely cap off the gas line. Details: Scope: Disconnect the gas oven and cap the gas line securely. Compliance: Must be able to provide a certificate of compliance/compliance plate update if required by local NSW regulations. Requirements: You must be a licensed plumber/gasfitter. Please state your license number or confirm you are licensed when making an offer. Appliance disposal: Not required (I will handle disposal/moving the oven myself)

When I connect pipe of my washing machine that connects to the water inlet (in the wall), the water starts leaking. I don’t know if it’s the problem with the pipe or what. So I needed help with it.

Dishwasher door isn't closing and install a wall clock

Need to repair lawn mower (John Deere Z235 zero-turn lawn mower) 1. Engine starts but the mower doesn’t move 2. Replace mower deck height adjustment wire 3. General yearly lawn mower maintenance Type of gardening: Other Size of garden: Above 300m² Has green waste bin: Yes

Im a small restaurant, my coffee machine was not heating up and there were no pressure from hot water wand and milk wand. I need asap service

Need someone to replace the seal of my lg washing machine. I have the part just need someone to install. Someone who’s done this before.

would no wash. go to a point in cycle and then came up with an error message ?E24? I tried to clean the collection basket in the bottom of the machine 3 times, still got the same message, third time a piece of plastic come off about the size of my distal thumb.

The washing machine needs to be connected to the water outlet. Need tool to remove cap

Looking for someone experienced with Dyson V11 vacuums to diagnose and fix a motorised head that is not spinning. The vacuum still has suction, but the roller/brush bar isn’t turning, so I need someone who can inspect it and determine whether the issue is with the cleaner head, connection, blockage, or another fault. Please include: • Your experience with Dyson V11 repairs. • Whether you can diagnose the issue first. • Your estimate for labour and any parts needed. • Whether you can repair it on-site or need to collect the unit. I’m after the most cost-effective repair option.

Hi, I need a licensed electrician to install a 70cm induction cooktop (new unit) replacing an existing electric cooktop. Details: • New cooktop already purchased (70cm induction – model SAI4744D) • Existing cooktop already installed and wired • Switchboard available (photos attached) • Located in Rouse Hill NSW What I need: • Inspect existing wiring • Install new cooktop • Advise if existing circuit can be reused • If new cable is required, please quote separately (don’t include in base price) Important: I’m looking for a cost-effective solution. If current wiring can support the cooktop safely, I prefer to reuse it. Please provide: • Installation cost (basic install) • Additional cost ONLY if new cable is required Thanks!