Find a reliable appliance technician in Reservoir VIC

Gas refill in a small display fridge

Connect hot,cold water and gas line to a kitchen Bbq with sink. Need to run services through cladding wall. Easily remove cladding to run services and put cladding back. Also need to cut decking board to access waste (already provisioned) for kitchen sink which is circled in red in the attached photo. If some form of cover can be placed over pipe work leading into cladding wall, that would be preferred.

Everytime I turn on my garbage dispenser the electricity cuts out. Have been working for 3 months since moving into the home.

The old cooktop died out of warranty. The new one needs an electrician to connect it. It's a Bosch cooktop and the house was entirely rewired 2 years ago so it should be straightforward.

Service and ? Replace oven element

Top loading fisherpykel, knocks loudly though my level says it’s level.

Hoover washing machine showing a error 8 and not spining

Need a door seal replacement I already have the new part to put in

Replace seal on front loader washing machine and give it a service

I have a Hisense 8i combo washer-dryer 12kg/8kg (Model HCF8I1215HB). There is lots of lint build up in the enclosure for the lint trap (e.g. behind and around the lint trap) as well as dried onto the rubber seal inside the drum. I've managed to clean half of the lint from the lint enclosure with a long nylon wire brush but unable to get the rest out which is impacting the drying performance. Looking for someone to do a proper clean of the internal lint enclosure/ducts (which likely needs the top panel of the machine removed) and a quick clean of the dried on lint in the drum. Please bring your own flexible vacuum hose attachments and any other equipment required.

Stovetop broke. New one is bigger. Need hole in composite stone enlarged

There are 2 jobs- Fix the hunger if an ilve free sta ding oven. Fix the sliding door lock Please quote for labour only and parts can be paid for on the day.

My washing machine (a Euromaid WM7) has a slow drip at the bottom of the plug in the image attached & would like this repaired. I've drained & cleared away any obstructions & the thread & rubber on the plug appears to be fine but it won't go past the anti-vibration locking notch.

Looking for a reliable plumber to check the dishwasher asap and fix. It seems to be leaking from the bottom. Thank you!

Need a range good light replaced. Don't have the light. Have key safe so can be done at anytime. Photo of light has details

Water leak in laundry area leaking washing machine taps

Need a plumber to connect new dishwasher. Also need to cut whole in the shelf it sits on to connect to existing PowerPoint. It’s a new Fisher and Paykel single dish draw.

Samsung fridge with reversible doors - need to adjust the fridge and freezer doors to open on right hand side.

I have a tall Vulcan Powerflue Wall Furnace gas wall heater in my house in Reservoir. The heater will be picked up by a buyer, and I need a professional to help with the following: Scope of work: Safely disconnect the gas line and cap it (licensed gas plumber required). Assist with removing the wall furnace if required. Remove the flue pipe and seal the external wall flue hole properly (weatherproof). Temporarily cover the large wall opening inside with a board or plasterboard for safety (I have a young child). The heater is approximately 1.8 m tall, so the wall opening will be large after removal. Location: Reservoir VIC Timing: Preferably today or as soon as possible. Please bring your own tools and materials needed for sealing the flue hole and covering the opening. I have attached a photo of the heater for reference. Thank you.

Hi, I have a Hisense front load washing machine (approx. 5 years old) showing F-03 error in the last 10–13 minutes of the wash cycle. What’s happening: • Error appears during the drain/spin stage • Pump filter has been checked and cleaned • Drain pump spins with normal magnetic resistance • Internal hoses checked – no visible blockage • No sludge build-up found • Drain hose not kinked The machine still errors near the end of the cycle. What I need: • Proper diagnosis of the F-03 drain fault • Repair or replacement of faulty component (likely drain pump, pressure sensor, or related issue) Please quote including: • Call-out fee • Labour • Estimated cost if pump replacement is required