Find a reliable appliance technician in Lower Plenty

Almost certain the motherboard is shot. No power whatsoever. Changed the power supply brick, but that wasn’t it. Was no signs leading up the power failure.

Treadmill is noisy needs service

Task is to repair a ride on mower and transport about 2kms. The mower is in good condition but needs a belt (I have spare part) attachment as well as new battery. Used to run perfectly but hasn’t been used for 2 years. I also have purchased new blades which I would like installed.

Mount dryer to wall, reverse the front panel on the new dryer and connect up exhaust tubing

My brother bought two inflatable Bluey’s from the USA back to Australia. We plugged one in, it got halfway inflated and then it stopped inflating. Got my sparky over, he plugged the other one in and the same thing happened. Then he said maybe it’s because USA is 120 volts vs Australia 240V. Not sure if we just need a transformer or if we need a new motor - both had a burning smell so suspect new motor. I have no idea how to fix these but am desperate to fix them for my kids to brighten up their end of year after such a difficult year we’ve had as a family. These were gifts from my brother for my kids and he’s spent $700 on them and now we’ve blown them as didn’t realise about the voltage difference. Devastated. Hoping the person that accepts this job can assist with sourcing the right replacement parts (at my expense) and repair to get the two Blueys going, one for Halloween and one for Xmas. I have attached some information from an inflatable store that may help guide the repair process, but as far as I can see there’s no details on the current motor unfortunately. Money is unfortunately tight and we don’t have much expendable cash but really hoping someone is able to assist us. Based in Lower Plenty. Pics attached to assist. Thanks for your consideration and kindness. Steph

Just looking for someone to do a Gas compliance and safety check on a house in Lower plenty, The house has a gas hot water and a gas stove top.

My portable aircon stopped working and I lost remote control. Most likely needs reset to work again. I checked drain and it's empty. Refer to photos for details, all lights are on when connected to power, however, I used manual "on/off" without remote and all lights were off, while working. Need expert with or without remote to reset the system.

Need to install security cameras on our property.

Install double oven into new cabinetry. Qualified electrician required.

Electricity, gas and fire alarm compliance check

Our electronic gate have stopped working and are now closed . The remotes aren't working and we don't have the manual key to free the gates. Price is per hour

Moved into a new house. Need a dishwasher installed asap.

I need someone to ensure my gas fireplaces work properly. They currently have very little gas flow and I need to ensure that they operate correctly with adequate flame and to ensure there are no gas leaks. Model is a Kalfire G90 and there are two identical fireplaces.

Grinder not working on Breville home machine

Breville home machine with integrated grinder. Grinder is not working and the filter size lights flash. Also has a small water leak which may be a seal issue.

Replace the drive belt on a John Deer L110 Rideon mower. The new belt will be provided.

I wish to add new connection to existing ducted heating, to make my bathroom warm in winter. Ducted heating located above ceiling and all existing doct tubes can be seen in photo. 2 to 4m tube might be required as well, depends on connection point. Bathroom that needs new connection located at far end in photo, about 4m from hatch. Access is via hatch. There is light & electricity. Flexible time but prefer to get job done in next 10 days.

Have a ranger ride on lawn mower in working condition that needs a service. I believe belts need to replaced or adjusted. Blades would be good to be sharpened and a full service required please. It is about 5 years old machine and I have been replacing oil and filter by myself.

I have an old remote with no battery. But it is not usable and needed to be reset with a new garage remote and programmed onto the garage.

turntable is making a clunking sound - suspect it is the motor