Hire a trusted stove installation and repair service in St Kilda

One control knob will not turn - it is currently off. Another is stiff and difficult to turn. Kleenmaid 4-burner stove top, probably from 80's. See image

I need someone to come and detached from the wall some stainless bench and shelf + the stove oven (include removal)

I have this gas pipe that I need reduced by about 40mm so I can get my oven in there. Also install gas stove and dishwasher if possible.

Chipped 2 burner induction stove top needs disconnecting & new one put in its place. Will need to arrange the keys with real estate or tenant to get access to the second story apartment. Qualified electrician only please. - Due date: Flexible

I’ve acquired an investment property and wonder if I can put in an electric stove and oven. Need help w installing - Due date: Flexible

Hello! There appears to be a problem with the ignition chain of my gas stove top. It just continues to click as though trying to ignite. I’ve held a flame to the plates but no gas appears to be coming out. When I push and turn down the button, the plates work fine. However, it’s like the ignite button is stuck or something? - Due date: Flexible

Need a new circuit from switch board to kitchen. Small ground floor apartment. Double brick. Existing stove (gas) and oven are being disconnected on Tuesday 20/6. Kitchen cabinetry is being removed on Wednesday 21/6. Floorboards in kitchen are being replaced Thursday 22/6 I would like circuit to run under floorboards and so the opportunity to do this is before they are replaced on Thursday. Can cut into floorboards in kitchen before then. I imagine at the switch board end (beside front door) the wiring would go to the floor encased in conduit, then maybe drill hole into edge/corner of floorboards to thread it under the floor, and then can come out at the kitchen at the back/side/underneath built in cabinetry (which will be replaced). Unfortunately the electrician organised through the kitchen repair coordinators has pulled out and so here we are! - Due date: Before Thursday, 22 June 2023

There is a combustible surface less than 200mm from the burner which does not comply with AS/NZS 5601.1:2013 Figure 6.3 (D). The surface would need to be protected in accordance with Appendix C. - Due date: Flexible

Gas stove top not igniting on 2 of the plates. - Due date: Needs to be done on Friday, 26 August 2022

We need assistance with the installation of an electric oven, a gas stovetop, and a dishwasher. These are all going into a pre-existing IKEA shell, and the appliances are ready to go. - Due date: Next week (commencing 14/12)

Hello, My new kitchen has been installed but the gas regulator is not letting the gas out. Need someone to come and fix, looks like it has been installed background. Location: St Kilda

Need gas stove installed with compliance certificate.

change filters and replace frame on rang hood. replace switch on electrical stove. In St Kilda 24hrs available to come over.

Hi there, I will need two tasks completed. 1) I am looking for someone that can uninstall an old gas stove top and oven and replace it with a new gas stove top and electric oven. Thank you 🙂

Commercial Gas Stove that needs service and clean.

Gas stove stopped working. Figured out it was stage electricity because it short-circuits the apartment when plugged in. Stove top is a Chef coordinate Series about 10-15 years old

Smeg gas stove top needing two cookers fixed - the big wok burner only lights a small flame, and one other burner is not working.