Book a trusted oven repair and installation expert in WA

We have a new oven that needs the gas jets changed over and hard wird to the existing15amp socket.

Oven seal i believe is the problem Door doesn’t close properly It could be just the door that needs tightening

Measure and let us know the model

Install oven and dishwasher

Replace old standalone oven/stove with a new one

The middle cooktop igniter is loose and won’t ignite the middle plate and the bottom left burner doesn’t have much flow. The oven display is not working and we need to know if it is fixable or not.

Need to get the inside of the oven replaced, the bottom has been scratch with a sharp tool leaving scratches.

Hi, I’m looking for a reliable and licensed tradesperson to replace my old 90cm electric oven with new one

Need to replace ignition switch for the burner for the ilve range oven

Need a licensed electrician to remove an old oven & install new supplied one by. Connect to existing power supply. Test and provide certificate. Discard old oven.

Need sparky for new oven installation/hardwiring, and new oven requires 15amp power, currently have 10amp power on old oven

Replace oven element model below

My oven smokes when I turn it on and my smoke alarms need checking as they make a beeping noise. I changed the battery in both smoke alarms but they still beeped.

Require an electrician to remove/replace 60 x 60cm wall mounted oven . Old oven is hardwired however the new Bosch oven comes with 10A plug connection. Scope of work: - Disconnect old hardwired oven - Install a 10A GPO in the oven cavity using the existing cable or potentially hardwire into the new oven? - Install new oven

Could you please help me buy a second-hand oven and install it? Quote must include the supply of the oven and the installation.

Renovating kitchen and pulled bench top off and realised there is a power point directly next to the gas pipeline. Looks like pipe may need to be heated and bent away from PowerPoint.

My oven power stops working. My friend (trainee electrician) fixed the switch which she said was not powerful enough. Then a few months later the same problem has happened again. I'm unsure if the issue is the oven itself or the wiring to the oven. Hoping someone can figure it out.

I am after someone to do the second and final sand render coat to my pizza oven, it is a DIY kit so all materials are supplied. The base is pre tiled so that would need to be protected and it is a colored render so it contains an oxide. I also have a number of repair work on both sand and acrylic render that need quoting on, it's on a planter box and a front wall.

Oven has been used twice, some grease needs removal from Oven and trays, Rangehood requires a degrease.

Just need a simple oven clean! Nothing high tech Small wall oven