Hire trusted experts for dishwasher repairs in Inner West Sydney

I’m looking for someone handy to connect a brand new dishwasher to the existing plumbing and power (the old one has already been removed). Just need it hooked up properly and tested to make sure it’s all working. Also need 2 x roller blinds installed — they each require 4 screws. You’ll need to bring your own ladder and drill. Located in Chiswick

BOSCH dishwasher works for an hour then stops after 1 hour with E09 error

I need a carpenter to remove the current drawers and a door to make space for a dishwasher. I have attached all the relevant photos

I need the person to install this dishwasher. It is small but I need to install it inside the carbs and also the hydraulic port. I'm also open to the person coming to see before wanting to do the job.Thank you

Pull out miele dishwasher and adjust pipes so it can drain again

Miele dishwasher F11 error code

Fix Bosch Dishwasher that runs for a half cycle then starts flashing E:25. Water is then left in the bottom of dishwasher. Need it fixed or replaced.

Smeg Dishwasher, error 01. I found some water at the base after removing the kickboard. Cleaned all the water, however, when I start the machine again, as soon as water is pumped into the machine, some water starts leaking at the bottom again. Happen even when I pour some water into the machine when it is off. Also notice the water level at the filter is also lower than it normally is.

The dishwasher isn’t turning on

Hi, I have two small plumbing / appliance issues at home: 1️⃣ Tap handle issue The tap handle turns right but won’t close, and only turns left to shut off. Possibly a reversed or worn-out cartridge. Need it repaired or replaced so the tap works normally. 2️⃣ Dishwasher issue (Omega ODW707XB) The dishwasher powers on and the display works, but no water enters during operation. Could be due to a blocked inlet valve, float switch issue, or water connection problem. Need someone to inspect and fix it so it fills and washes properly again.

After closing the door, it is not triggering to start the machine

Miele Dishwasher is throwing up an F70 error. Prior to this it had a high pitched whine for a few days and was acting up. Filter is reasonably clear. Suspect sump might have died on us?

Need dishwasher repaired. It is a Miele that has a F24 error message . If you know what it is please advise if can be repaired

Old dishwasher needs to be removed

SMEG dishwasher lights flashing - pump runs but then switches off and lights start flashing

Looking for a qualified plumber today to: • Drill a hole into a timber benchtop and install a new kitchen tap (English Tapware). • Connect the new sink (already in place). • Connect new dishwasher (already installed in the cabinet). • Connect new gas cooktop. Additional info: • We can reimburse you for any extra parts you may need to complete the job. • Bunnings is just around the corner for any last-minute supplies. Must have: • Relevant plumbing and gas fitting licences. • Tools to drill through timber benchtop. • Availability to complete this today.

Need a new dishwasher to be installed (old one will be disconnected and removed already) All existing pipes and drainage in place, just need someone suitably qualified to install it and test run it.

Unclog dishwasher - water won’t drain. Model is a Whirlpool.

Door hinge on integrated dishwasher over extended and now dishwasher door won’t close

Miele dishwasher is getting an error code f24 after starting a cycle