Find a reliable cooktop installation and repair service in VIC

My gas cooktop is not working properly. The largest (centre) burner cannot work properly. After it is turned off, it cannot be ignited again immediately. I need to wait for a period of time before it can be lit again.

Replace gas cooktop with a new one

I need a licensed professional to replace the existing cooktop (90cm) with a new Westinghouse 90cm Dual Fuel Freestanding Cooker (same size 90cm). Ensure installation complies with Australian standards. Test the appliance and confirm safe operation. Supply a relevant certificate of compliance. Oven Fuel Type: Electric Cooktop Type: Gas Cooktop Fuel Type: Natural Gas Any questions, please ask. Thank you

Prior to commencing works carry out gas fitting line pressure test to ensure sound -Isolate gas to property, remove existing cooktop, and fit new gas isolation valve under bench in approved location to meet current regulations -Fit new customer supplied gas cooktop, including regulator, and connect to fitting line (Chef CHG644SC) -Carry out secondary gas fitting line pressure test -Commission appliance as per manufacturers instructions -Clean area and remove all rubbish including original cooktop from site for disposal -Supply relevant certificates of compliance

Hi need help.installong electric induction cooktop.fix power switch in kitchen

Cap gas line where old cooktop is being removed and supply certificate

Rectify upright freestanding gas cooker with a high level hose connection. Instal an isolation valve.

Need a new induction cooktop installed and an old electric one taken out. Both cooktops are same dimensions so shouldn’t need to do any cutting of the bench. New cooktop needs to be hardwired but old one only required a plug so this needs to be taken into consideration. Refer to photos of old cooktop and switchboard.

the new induction cook top needs to be installed, while the old gas cook top needs to be removed. the dimensions could be different, therefore it the bench might need to be cut. the gas will be disconnected and closed. the task will require an eel

Licensed plumber required for the installation of new gas cooktop. 600mm 4 burner. Gas to unit is off, existing lines as pictured. New unit product code- the hood guys: GGSCG6004. Compliance certificate required upon completion.

Hi, I need a technician to install a new Westinghouse 60cm 4-Burner Gas Cooktop – in my apartment located in Melbourne CBD. • New cooktop is already onsite and already fitted in.

Need a plumber to connect a new gas cooktop which needs to be safely connected to the gas port. I can provide the cooktop but need the plumber to provide the regulator and connect to the port. Need done before 10am Friday, either later this afternoon or tomorrow morning.

I need a handyman / stone benchtop specialist to slightly enlarge an existing granite benchtop cut-out so a new cooktop fits correctly. The cooktop is already on site but does not sit flush — the cut-out is a few millimetres undersized / out of square. Job is located in city ( on La Trobe St) There is off street car park

• The existing electric cooktop is faulty and needs to be removed and replaced. • I haven’t bought the new cooktop yet. • You can buy this electric cooktop from Bunnings and I’ll reimburse the full cost: https://www.bunnings.com.au/bellini-60cm-4-burner-electric-cooktop_p5102272 It’s the same size, same cut out So pretty much straightforward

Replace induction cooktop with another one. I am not sure but I think the old one is connected to a 25A. The new one might need a 32A circuit. The switchboard already includes a dedicated switch for Cooktop. Photo attached. You can check what amph is required for the new one to make sure. No need to cut the cabinet as both have same cut size. Certificate of the installation is required from a certified electrician. Location is Holloway road, Croydon North Please send me reasonable offers.

I can supply the cooktop. New installed and old unit taken away. Also would like to understand what supply and install price as well.

I have a second hand gas cooktop I want to replace Second hand cooktop in first pic Old cooktop in second pic Removal and installation required

Remove the existing gas cooktop, and install the new gas cooktop. The old cooktop needs to be taken by yourself for disposing it.

Remove existing gas cooktop and install replacement gas cooktop. Cooktop cavity size & gas line does not need alteration.

I need a certified plumber to come and remove my old gas cooktop and cap the gas connection in the kitchen.