Find professional window and door services in Balga

Fix the damage of the dent and paint on my car door

We require a registered ABN handyman or contractor to provide a quote for the removal of 5 adhesive backed child locks from internal doors ideally without damaging the paint. If damage cannot be avoided, an itemised costing of repairs potentially required to return the doors to how they were prior to child lock fitment should be provided in the quote also. All quotes considered. Thanks in advance, Stu

Need a few door frames painted and one lock put back on And need a vent reached on ducted air con so I can clean

Shed roller door needs a good servicing.

Need 1 x bathroom door shaved by perhaps 1cm. Unable to have any bath mats on the floor while opening and closing door as it’s too low to the ground

The Front door has move off the hinge and hard to close

Need to replace the mesh / flyscreen at the front security door. I bought an Heavy Duty Flyscreen roll at Bunnings, but I don't have the tools or know how to do it.

Leaking Window , Requires Rectification

someone kicked in my front wooden door and flyscreen door - Due date: Flexible

Hi there, I need someone who can put a door frame + door here and place bricks around the side

Opening in and out bathroom door is broken. It is not a sliding door

Brought this new door knob, would like to install asap

I have a door that I would like hung in place of the old door; in the lounge room. The hinges are on both doors, but are in different spots on the door frame to the old ones. I would like to keep the door hinges on, so new frame hinges templates will need to be chiseled out. Also the door knob fixture will also need to be chiseled out of the frame as the doors have different knob templates. Please fill in the old chiseled gaps with wood filler.

I need a new internal garage door supplied and installed due to the old one rotting from water ingress.

Looking for quotes to replace and install 2 new external doors aswell as swap the frames around so the security screens are on the outside and doors on the inside. We will supply the new external doors Please quote for total job and any other materials needed.

Hi, I need someone to install a door handle set. Thanks

After 2 doors as per the attached photo purchase and delivered: 1) 1st door 820 x 2040 x 35mm Internal Door Primed MDF Flush H1 To have a 54mm face hole and a 25mm hole for the latch as well as a mortise for 3 hinges 2) 2nd door Hume 2040 x 820 x35mm External Door Duracote flush STPC to be cut to a width of 285mm as well as a 54mm face hole and a 25mm hole for the latch. Would need the face hole and latch hole to be measured to match existing latch before drilling.

Approximately 5 metres of eves need to be set up near the front door.

Cut door to size and cut hole for door handle/lock

Door needs to be cut to size and then a cut for the door handle/lock. Thank you