Hire a professional washing machine repair service in Inner South Melbourne

Need someone to replace the rubber seal on washing machine, I have purchased the part form the manufacturer

We have had a washing machine delivered. We require 2m hoses and a modification to the pipework to allow for hot water to machine as it appears only cold is provided. Cold pipe is photographed.

The slot for the machine machine has no access to the plumbing connections. I need one cut through. Then ideally connect up the machine.

need to connect cold water outlet/inlet of washing machine in new rental property I have just moved into. I'm not sure if the cold water outlet tap fits the washing machine inlet hose. The outlet is currently capped.

I have an AEG 6000 Series ÖKOMix washer dryer that has suddenly stopped working. The machine powers on normally. As soon as I start any wash program, it immediately starts the drain pump. It does not fill with water at all. The drain pump continues running continuously. There are no obvious error codes displayed. The water supply valve is fully open, and the house water supply is working normally.

Washing machine connection. Needs holes drilled and an extra long cable from bunnings to connect to water taps a cabinet over.

Attach water hose and outlet hose

My washing machine has been stuck and is not draining the water. The water is flowing in and I can start the cycle but it won’t drain.

Lock sign is flashing and no cycle will start We have tried: Holding the start button Turning machine off for 5 mins and back on Changing cycles Removing washing from machine

Require a handy person to remove a door, install a washing machine and then install the door again. Most of the hinges are off the door just one holding it in place.

Hi takers, I need help replacing the rubber seal on my washing machine. I have the part ready to go. See pic for washing machine. Electrolux 7.5 EWF725DQWA

I think there’s a block in Washing machine

My Fisher and Paykel washing machine stops during the rinse cycle with a “clear filter” error. I have cleaned the filter and there is nothing stuck in it but the error comes back after I resume the cycle. Need someone to fix the problem. Model WH7560J3

We've recently moved into a new property and need help reconnecting our washing machine. The AquaStop inlet hose was originally connected to the hot water tap. We attempted to move it to the cold water tap ourselves, but access is difficult due to a large water pipe obstructing the connection. As a result, the hose is currently disconnected and not connected to either tap. We're looking for someone who can reconnect the AquaStop hose to the cold water tap and check that everything is set up correctly. The washing machine is already in position and I have attached photos for reference. No new parts should be required, I’m hoping for a simple reconnection rather than a full plumbing call out.

Help me untwist the hose from tab

Our tenant used the washing machine and a bar underwire is now stuck under the drum

I need a plumber to replace my kitchen sink tap (tap supplied) and connect my washing machine drain hose extension (supplied for you too) to existing under-sink plumbing. All plumbing points already in place. Straightforward apartment job.

Hello! When I moved in, the washing machine was connected to the hot water tap. I need it switched to the cold water tap please. The connection is just too tight for me to unscrew myself.

Need a tap changed in laundry sink and washing machine stoppers changed

I need someone to drill a neat access hole in the side panel of my laundry cabinet so the washing machine inlet hose can pass through to the water tap located in the adjacent metal cupboard. Please also fit a white plastic grommet for a tidy finish if available. I gave it a go before realising my drill bits were for wood only 🤦🏻‍♂️