Find professional handyman services in Nevada

Install (2) 4x8 Ceiling Racks in my Garage / Can Pay $100 to install ASAP!

Drone landed on my neighbors 2 story roof upside down

Finish building a smith machine Lay rubber tile jigsaw floor in garage Move heavy gym equipment

The drawer itself is fine. It’s the panel that secures the handles and fasten onto the actual drawer with 3 nails on each side

My front door on the inside where the door closes is cracked really bad. Also there's big gab

Install curtain and 2 accessories on wall

I need 10 of these blinds installed. Different sizes, but they are super light and cordless. You basically just have to follow the instruction from Amazon.

You will need to remove the old screen door and clean up any necessary blocks. That’s holding the hinges up from the old door. I’m looking for a completely flush factory look please see instructions below Installation Guide for Cavco Rear Door Storm Door **Important:** Follow all instructions carefully to ensure a successful installation. #### Materials Provided by You: - Cavco rear door storm door (with all necessary hardware) #### Materials to Be Provided by Installer: - **Sealant/Caulk** (e.g., OSI Quad or DAP 3.0) - **Butyl Putty Tape** (if not included) #### Tools Needed: - Tape measure - Hacksaw - File or sandpaper - Screwdriver - Drill with a 1/8" bit - Level --- #### Steps: 1. **Measure Opening Height** - Measure from the bottom threshold to the top trim edge. Record the height (typically **79.5 to 80 inches**). 2. **Prepare the Z-Bars** - Locate the hinge-side and latch-side Z-bars. - Mark a line on each rail from the top edge down to your recorded height. 3. **Cut the Metal Rails** - Use a hacksaw to cut along the marked lines. Smooth edges with a file or sandpaper. 4. **Mount the Top Rain Cap and Hinge Rail** - Position the rain cap against the top trim and secure with screws. - Lift the storm door with the hinge Z-bar into the opening. Use a level to check alignment. - Drill pilot holes and secure with screws. 5. **Mount the Latch-Side Rail** - Close the door and insert the latch-side Z-bar, maintaining a **3/16" gap**. - Press it against the house, pre-drill, and secure. 6. **Install the Bottom Expander** - Slide the expander onto the door's bottom edge. Adjust it, then secure it with screws. 7. **Ensure a Tight Seal** - Open and close the door to confirm smooth latching. Inspect for gaps; adjust as needed. 8. **Seal Installation** - Apply sealant/caulk along the metal rails’ outer edge for air and water tightnes

Chair legs are broken for dining table. My sink disposal is making a noise the blade is broken. My sink in my upstairs bathroom won’t hold water and i have a drawer in my closet that is broken

Locked out bedroom used shoulder to get in doorway split

Finish bidet add on to toilet install - have it connected but can’t put everything back together as tight space and unable to reach. Have 2 6x8 framed pictures, 6 ft white board and a 3 ft white board to hang.

My disabled son put holes in his wall and i need them fixed

I need a valance installed above my kitchen sink. I can’t get the right angle to put up the curtains.

Assist experienced sign installer to replace signs at a gas station. Job is for 3-4 days, starting early in the morning to avoid heat. Experience in sign installation or ladder work preferred. Rate is per day, but job is 3-4 days

2 small holes in the walls that need to be repaired

I need someone who knows how to read directions and assemble a home gym correctly

I have a large mirror in my hallway and would like it painted.

I have 4 TVs to be mounted and 2 kids beds

I need my ceiling fan taken down and replace original light fixture today, please I’m moving ASAP

Fix the garage door can’t close please let me know as soon as possible thank you 😩