Find professional windows and doors services in Nevada

Need clear rubber strips replaced ( bottom and sides) all around the shower door in upstairs master bedroom.

I need One external electronic dog door installed in a metal door

take this slider off so the access is bigger to fit a grill through it and then put the door back

Fix holes two small ones on bathroom door one small one near floor

Install metal security to the outside of the front door.

I would like for someone to come perfectly patch up these 2 holes and bring 2 door stoppers if possible. Today

My garage door opener broke. I'll buy the new opener and would like someone to install it make sure everything works correctly.

Standard sliding glass patio door. Replace wheels and clean the track.

My front door jam is cracked and there's a big gap

Front door on the inside where the door closes is cracked and there's a gap

My front door on the inside where the door closes is cracked really bad. Also there's big gab

My door doesn’t fit my door beacuse the bottom is too long the door fits frame but the bottom is too long

You will need to remove the old screen door and clean up any necessary blocks. That’s holding the hinges up from the old door. I’m looking for a completely flush factory look please see instructions below Installation Guide for Cavco Rear Door Storm Door **Important:** Follow all instructions carefully to ensure a successful installation. #### Materials Provided by You: - Cavco rear door storm door (with all necessary hardware) #### Materials to Be Provided by Installer: - **Sealant/Caulk** (e.g., OSI Quad or DAP 3.0) - **Butyl Putty Tape** (if not included) #### Tools Needed: - Tape measure - Hacksaw - File or sandpaper - Screwdriver - Drill with a 1/8" bit - Level --- #### Steps: 1. **Measure Opening Height** - Measure from the bottom threshold to the top trim edge. Record the height (typically **79.5 to 80 inches**). 2. **Prepare the Z-Bars** - Locate the hinge-side and latch-side Z-bars. - Mark a line on each rail from the top edge down to your recorded height. 3. **Cut the Metal Rails** - Use a hacksaw to cut along the marked lines. Smooth edges with a file or sandpaper. 4. **Mount the Top Rain Cap and Hinge Rail** - Position the rain cap against the top trim and secure with screws. - Lift the storm door with the hinge Z-bar into the opening. Use a level to check alignment. - Drill pilot holes and secure with screws. 5. **Mount the Latch-Side Rail** - Close the door and insert the latch-side Z-bar, maintaining a **3/16" gap**. - Press it against the house, pre-drill, and secure. 6. **Install the Bottom Expander** - Slide the expander onto the door's bottom edge. Adjust it, then secure it with screws. 7. **Ensure a Tight Seal** - Open and close the door to confirm smooth latching. Inspect for gaps; adjust as needed. 8. **Seal Installation** - Apply sealant/caulk along the metal rails’ outer edge for air and water tightnes

Locked out bedroom used shoulder to get in doorway split

Hi-Tech electronic/electric dog door to be installed through wall.

Paint the garage doors, I will supply all materials and equipment. Need someone who responsible, male or female.

I will supply all materials and tools.

I need 2 cat doors installed in my garage that will lead to an enclosure. I also have several cat shelves that I need hung up in house

Or at least super clean. Bring whatever you think will accomplish job.

I have loose drawers off track and hanging, a broken cabinet & another that’s loose, a door completely off the hinges, and a closet door off track. Please be willing to have any tools/supplies needed.