Find professional windows and doors services in Sunrise Manor

I need One external electronic dog door installed in a metal door

I would like for someone to come perfectly patch up these 2 holes and bring 2 door stoppers if possible. Today

My door doesn’t fit my door beacuse the bottom is too long the door fits frame but the bottom is too long

You will need to remove the old screen door and clean up any necessary blocks. That’s holding the hinges up from the old door. I’m looking for a completely flush factory look please see instructions below Installation Guide for Cavco Rear Door Storm Door **Important:** Follow all instructions carefully to ensure a successful installation. #### Materials Provided by You: - Cavco rear door storm door (with all necessary hardware) #### Materials to Be Provided by Installer: - **Sealant/Caulk** (e.g., OSI Quad or DAP 3.0) - **Butyl Putty Tape** (if not included) #### Tools Needed: - Tape measure - Hacksaw - File or sandpaper - Screwdriver - Drill with a 1/8" bit - Level --- #### Steps: 1. **Measure Opening Height** - Measure from the bottom threshold to the top trim edge. Record the height (typically **79.5 to 80 inches**). 2. **Prepare the Z-Bars** - Locate the hinge-side and latch-side Z-bars. - Mark a line on each rail from the top edge down to your recorded height. 3. **Cut the Metal Rails** - Use a hacksaw to cut along the marked lines. Smooth edges with a file or sandpaper. 4. **Mount the Top Rain Cap and Hinge Rail** - Position the rain cap against the top trim and secure with screws. - Lift the storm door with the hinge Z-bar into the opening. Use a level to check alignment. - Drill pilot holes and secure with screws. 5. **Mount the Latch-Side Rail** - Close the door and insert the latch-side Z-bar, maintaining a **3/16" gap**. - Press it against the house, pre-drill, and secure. 6. **Install the Bottom Expander** - Slide the expander onto the door's bottom edge. Adjust it, then secure it with screws. 7. **Ensure a Tight Seal** - Open and close the door to confirm smooth latching. Inspect for gaps; adjust as needed. 8. **Seal Installation** - Apply sealant/caulk along the metal rails’ outer edge for air and water tightnes

I need 2 cat doors installed in my garage that will lead to an enclosure. I also have several cat shelves that I need hung up in house

I need a screen door installed on my home that has never been a storm door or screen door installed there. If you can see in the photos this is a standard pine screen door. I have all the hardware necessary to hang it. I have a hinge kit with the handles and everything else. I do not believe there’s anything else that will be needed. I also need to have part of the weatherstripping replaced on my main door for this door is gonna be going out because of animals have tore up the seal. You can see in the pictures of the piece I need replaced. I believe I have enough to do that.

Replace door jam and install lock

I have purchased the screen door and the new door. I will need to door frame fixed, new handled installed and the doors installed

Front and side windows have pleated drapery hanging devices for two sets of draperies (front and back). The back ones are hung but needs a few eyes replaced for hooks. The front draw draperies needs to be hung after all eyes are in place for hooks This task is needed for side window of living room also.

Door frame snapped wondering if we can just fix that part

Fix door frame attach door

My bedroom door has a big hole I need it replaced

My bedroom door frame gave out on the top of the door and the bottom screws stripped out at same time. Just trying to replace that part of the frame if possible or full frame and re use the door will provide pictures if needed when I get home

just a little scratch could be a little deep on side door

Small hole repair in closet door