Find a local Tasker to replace your engine in California

I put the diesel instead of gasoline I still didnt turn on the engine. The car is Ford Focus Sedan 2012 SEL.

Car cranks but no start and there’s no check engine light on 2005 Acura TL 3.2

Needs a car engine replaced. I have the part and tools if needed. 2003 saab convertible. 2 door. Except a cherry picker.

I just bought a car part ( an engine assembly for an i3). I need help moving it from the delivery vehicle into my trunk. Will take about 15 mins

Looking for a highly experienced mechanic to finish a partially completed same-engine swap on my 1990 Ford Bronco 5.8L / 351 Windsor EFI V8. This is NOT a full engine swap from scratch. The original engine has already been removed, and the replacement 5.8L engine has already been lowered into the engine bay. The truck is currently mid-install. The engine still needs to be properly pushed back/aligned, seated onto the motor mounts, mounted, connected, and prepared for startup. The truck has about a 6-inch lift, so please keep that in mind. You must have your own tools and equipment, including a hoist/cherry picker if needed to safely reposition the engine. Current condition: • Replacement engine is in the engine bay but not fully seated/mounted • Upper intake manifold is off and available • Radiator is currently out • Replacement radiator and replacement fan are available • Coolant, transmission fluid, engine oil, and other fluids are already on hand • Replacement engine has a new oil filter installed • Original engine is available for reference/parts if needed Remaining work may include: • Final engine positioning and motor mount alignment • Verifying transmission/bellhousing alignment • Reconnecting engine wiring harness and grounds • Starter connections • Vacuum line routing • Fuel line/system connections • Cooling system, radiator, fan, and hose connections • Upper intake manifold installation • Accessory/belt verification • Fluids, pre-start inspection, startup, and troubleshooting if needed Please only respond if you have real experience with Ford 5.0/5.8 EFI engines, OBS Ford trucks/Broncos, engine swaps, wiring, vacuum routing, and startup troubleshooting. I need someone who can look at the current state, confirm what else may be needed, and finish the swap properly and safely. Please include your experience, earliest availability, whether you have the tools/equipment needed, and whether you’re confident you can complete.

Car been sitting up for years need to be clean so I can fix the engine

remove broken bolt from engine block any questions feel free to ask negotiable

I have a2013 Fiat 500 Abarth 5 speed manual. After replacing knock sensor the check engine light came on again, it needs a complete engine bay harness. I’m looking for someone who can do the job as expected. I have a used set since Mopar don’t make it anymore .

I have a 2020 Subaru outback and I need help taking my engine out

2025 R3 only read a few times I believe it’s the fuel pump. I’ve charged the battery. Not sure why it’s not starting also to install the short tail fender eliminator.

the fan is not coming on next to the radiator

2015 gmc terrian check engine light on p0411 changed already the secondary air injection and the vavles. Code comes back on. Also need the front end check out lots of sqeeking

Lower engine bay completely cleaned

2018 Honda HRV engine won’t turn over

Replace engine valve cover on a Dodge Charger. I have the new one. But it will need a cap as well, which I don’t have.

All lights came on. Nissan sentra 1.8 4 door, 72300 miles. Battery replacement is only repair in past.

Found engine coolant leaking on engine. Seems like a leak in the line. Engine was clean but now had orange engine coolant glazed on top of it.

Remove all grease, and dirt build around top to all way to the middle and low end of engine

A dead rodent is visible in the engine bay. It is not caught in a belt. It appears lodged to the left side. I do not need repairs. I need someone to remove it.

Dodge challenger 2019 check engine light