Find a local Tasker to replace your engine in Los Angeles

I have a 2016 Mazda3 2.5L Skyactiv (144,000 miles) that needs an experienced mechanic to diagnose an engine noise. Symptoms: Loud metallic knocking/ticking noise from the passenger/front side of the engine. Noise increases with RPM and is noticeable at idle. New metal-on-metal squeaking noise immediately after startup. Engine shook/vibrated at idle on one occasion. Check engine light with knock sensor code (P0327/P0328). What I need: Diagnose the source of the noise before replacing any parts. Determine whether it's coming from the accessory drive (belt, tensioner, idler, alternator, A/C compressor, water pump) or inside the engine (timing chain, VVT, valvetrain, etc.).

Needs a car engine replaced. I have the part and tools if needed. 2003 saab convertible. 2 door. Except a cherry picker.

I just bought a car part ( an engine assembly for an i3). I need help moving it from the delivery vehicle into my trunk. Will take about 15 mins

Looking for a highly experienced mechanic to finish a partially completed same-engine swap on my 1990 Ford Bronco 5.8L / 351 Windsor EFI V8. This is NOT a full engine swap from scratch. The original engine has already been removed, and the replacement 5.8L engine has already been lowered into the engine bay. The truck is currently mid-install. The engine still needs to be properly pushed back/aligned, seated onto the motor mounts, mounted, connected, and prepared for startup. The truck has about a 6-inch lift, so please keep that in mind. You must have your own tools and equipment, including a hoist/cherry picker if needed to safely reposition the engine. Current condition: • Replacement engine is in the engine bay but not fully seated/mounted • Upper intake manifold is off and available • Radiator is currently out • Replacement radiator and replacement fan are available • Coolant, transmission fluid, engine oil, and other fluids are already on hand • Replacement engine has a new oil filter installed • Original engine is available for reference/parts if needed Remaining work may include: • Final engine positioning and motor mount alignment • Verifying transmission/bellhousing alignment • Reconnecting engine wiring harness and grounds • Starter connections • Vacuum line routing • Fuel line/system connections • Cooling system, radiator, fan, and hose connections • Upper intake manifold installation • Accessory/belt verification • Fluids, pre-start inspection, startup, and troubleshooting if needed Please only respond if you have real experience with Ford 5.0/5.8 EFI engines, OBS Ford trucks/Broncos, engine swaps, wiring, vacuum routing, and startup troubleshooting. I need someone who can look at the current state, confirm what else may be needed, and finish the swap properly and safely. Please include your experience, earliest availability, whether you have the tools/equipment needed, and whether you’re confident you can complete.

Car been sitting up for years need to be clean so I can fix the engine

remove broken bolt from engine block any questions feel free to ask negotiable

I have a2013 Fiat 500 Abarth 5 speed manual. After replacing knock sensor the check engine light came on again, it needs a complete engine bay harness. I’m looking for someone who can do the job as expected. I have a used set since Mopar don’t make it anymore .

2025 R3 only read a few times I believe it’s the fuel pump. I’ve charged the battery. Not sure why it’s not starting also to install the short tail fender eliminator.

the fan is not coming on next to the radiator

Dodge challenger 2019 check engine light

BMW older 2004 X3 I replaced most of the hoses but there's still a few that are just going out and it looks like I need one hose I believe

My car isn't passing smog since the check engine light is on and the diagnostic is not reading. The car is a 2006 Audi A4 and the check engine light has been on for 2 months.

I'm being told to replace my audi because of my engine, but this was a sudden update after getting my car fixed twice an auto mechanic.

2005 toyota highlander v6 po171 and po174 i was trying to check engine light and then it showed that i tried changing the maf sensor still happened then the air filter and still showed up

It don’t drive rite check engine light is flashing

My car was towed to a shop called Loyola marina auto car because the starter engine does not works anymore. However they are quoting me a price I cannot pay. So, I need to find a way to install a new starter engine.

Oil from engine looks like chocolate shake car no longer runs or turns on overheating before fan wouldn’t turn on when it supposed to Coolant water would leak out under car by were coolant goes.

Engine coolant overheating

2012 Mercedes Benz C250 Coupe. TRS ($700) or Transmission Module ($1000. Depends on which need to be replace.

Need to get diagnostic test to see why my car check engine lighy and traction control lights are on in my car.