Find a professional gate installation in West London

Anyone local around to quickly rescrew baby gate back in my brick wall

I have purchased gates to replace current gates. These will arrive next week. I would also be requiring the hanging of internal doors in the future.

Remove old brick wall, build new wall and install iron work fence and gate

We need you to: 1. Remove Existing Gate Cut out and remove old iron gate (i.e. with angle grinder). Take the old gate away. 2. Fit New Gate & Fence Spraypaint new gate and fence with Tygris Black Matt before fitting. Fence: 413 cm L × 52 cm H. Gate: 88 cm opening, 107 cm H. Note: - The fence is approx 100kg and will require a team of 2 to fit - It is advised that resin is applied in the drill holes for added stability - You'll need to supply the tools (angle grinder, drill, dropcloth for spraypaint, etc.). I will supply the Tygris spray and required fixings. The manufacturer has advised it will take approximately 3 hours to spraypaint and fit the gate and fence.

Safety gate fitted to wall each end drilling will be required!

Installation of Two rear Garden gates. Will require putting cement post mix for base ( provided) and assembly of gates. ( see image)

Current fence panel needs to be changed so we add a gate into the straight section of fence to accommodate access for a mobility scooter. The other existing gate must stay (this can not be used for access as there are posts on the other side which prevent access for a scooter) Chertsey location and want it completed as soon as possible.

I need someone to replace two support posts and garden gate

Slight sanding of front gate required and then add 2 coats of varnish. Must be done this Friday/sat as will be good weather

Log cabin has been repaired. Need to treat new fascias on roof, door centre, areas where no stain inbetween logs all around small areas to work the stain in, inside treat floor. I have the walnut stain and the clear for the inside. Also fix gate which is not aligning with bolt and needs a metal receiver for the bolt so it doesn't keep dropping I think

We need a child gate at our front door. We have a pine cot to use for materials

Paint 9 panel front garden fence & posts with 2 coats of paint both sides and both sides of 2 garden gates and a bin store. Important no paint splatter goes on path or drive. Will provide paint, brush and protective coverings. Should take no more than 1 day. Job to be completed in one session. Experience & references preferred. Please don’t apply if you are outside of my budget by more than a few pounds. Thanks

Gate post is weak so needs replacing

Gates have dropped, therefore unable to open and close with a remote. Not sure of cist. Please give a quote

Need repair on front garden wooden picket fence. 2 rotten gate posts need removing & replacing (concreted in). Existing gate to be reattached. New latch to be installed. Size: 3×3 inch thick posts, 37 inch into ground. Quote: Please give labour and materials cost separately. Near Harrow Wealdstone station

A gate to be custom made. Pretty straightforward. Frame to be made with treated timber. Vertical planks to.cover. Hinge and fit. Car needed to go and get parts if necessary. Timber supplied. Shops nearby

Take bolt off gate, drill new holes further up so the bolt actually fits in the hole which will allow the gate to be closed properly. (Tools/drill not supplied)

Garden Gate/fence has grown loose from its foundations and is not secure

I need a side gate fitting back onto the wall. It’s a full size door.

Old heavy duty padlock and thick chain left on metal gate. Needs cutting with bolt cutters and throwing in bin.