Find a professional render contractor in WA

Looking to get my outside kitchen rendered. It’s roughly 3600 long and 620 wide. Will render over cement board.

White plaster some walls Walls already rendered See photos

Need my outdoor kitchen rendered. It’s done in cfc sheets. Want it done the whole way around the kitchen . It’s aprox 3600 length.

Free-standing garden wall is 20m long and 2m high and should be prepared and smoothed over (rendered/plastered) with cement.

I clipped the edge of the render with my car and I need it repaired

I’m looking for someone to build a curved rendered outdoor bench seat. Measurements 2800mm long, 800mm wide, 600mm high. The bench seat is to follow the slab in the photos & look something like the example photo. Thanks

Outside wall needs to be rendered and painted. One inside wall requires patch and paint.

Need the external walls to the back of our house rendered. I can supply material (you just need to get your tools and mixers). Not a big area (~20 M2).

Render on wall has peeled and cracked in some spots hoping to get it touched up and brought back to life , main job would be the garden bed wall others are just small peelings and chips along the front of the house walls

Renovate a rendered band on front of house

Small area of render cracked away needing repair

The render at the end of the brick fence has come off in patches Might need to be recovered but a patch up is fine

I need repairs to some external rendering. The rendering covers the lowest six brick courses and is degraded. There is also rendering on some brick pillars which needs replacing/repairs.

I have front fencing job done, require rending on it

Hi there, I am looking to get a quote for rendering and texture coating the front brick fence at our property in Willetton WA6155 The fence is built on a limestone base and consists of brick infill walls and two pillars, as shown in the attached photo. Scope of work required: • Float/render coat to a smooth, even finish. • Application of an acrylic texture topcoat Could you please provide an estimated cost and your current availability to take on this job?

We are looking for an experienced painter to paint a newly concrete rendered L-shaped planter box at a residential home in Brabham WA - approximately 5mx3m in length. You will have access to the backyard where the planter box is via a side passageway which is approximately 0.6-0.8m in width and ~25m from the front. What we will supply: - Paint + Primer/Sealant - recommended product type and quantities TBC and advised by the person completing the job. What you will supply: - All other remaining tools and equipment required to paint the rendered planter box. Please reach out with any further enquiries.

I have had some renovations done and have patches of exposed brick which need to be rendered.

I need an area of approximately 5 square metres of Bester Blocks rendered. The area is the back and bottom of a garden seat.

Just knocked down some small retaining wall at the front of the house. Looking to patch up the joining areas. Will need to grind down some of the protruding brick and patch up the sand finish render. 6 small spots.

We have built an outdoor barbecue/kitchen area out of brick on our veranda. Although most will eventually be stone clad , i’m wanting it rendered first. My estimate is that it is about 14 square metres. (ignore the ticks and crosses on the pics. These show what areas will ultimately be stone clad and which will remain exposed render). Not sure on the colour but it would be something grey/ cream/beige. Would like price to include both the render and the labour. I don’t know if this helps, but we have heaps of yellow/brickies sand available. Would need to be careful of our timber decking. (We do have a roll of cardboard sheet if this helps). Would like done as soon as possible.