Find local air source heat pump installation & repair in NSW

I’m looking for a licensed electrician to install an outdoor weatherproof power point for a new heat pump. Scope of work: • Install 1 x outdoor weatherproof GPO (power point) on the external wall in the location I’ll show you. • Power is already available on that wall: • Existing internal power point directly behind the desired location, and • Another existing power point approx. 10 metres away on the same wall outside. • You can choose the best option to tap into, as long as it complies with regulations and load requirements. • Outdoor power point unit will be supplied by me. • You to supply all other materials: cable, conduit/trunking, fixings, etc. • Test the circuit, ensure it’s RCD‑protected, and provide any required certificate of electrical safety/compliance. Requirements: • Must be a licensed electrician (please include licence number in your offer). • Experience with external/weatherproof power points. • Clean, tidy work and must make good any small penetrations made. Timing: • Flexible on day and time – ideally within the next 1–2 weeks. Please let me know: • Your approximate total price (labour + materials, excluding the power point itself), and • When you’re available.

Pool Heat Pump– Compressor Humming & Shutting Off Likely Capacitor. My pool heat pump has stopped heating properly. The fan still runs, but the compressor makes a loud humming sound for 2–3 seconds, then shuts off, and this cycle repeats. The water temp stays stuck around 23°C even though the system is set to the mid-30s. The unit is 6 years old, and based on symptoms, this is almost certainly a run/start capacitor failure on the compressor side. I need a technician who can: • diagnose the issue • replace the faulty capacitor (likely 30–80 µF depending on model) • check compressor startup and system function • ensure proper heating output

Bosch heat pump dryer needs extender and connect simple and easy

Install heat pump dryer on top of washing machine using stacking kit

The dryer is working but has loud noise from the back when running

Looking for a licensed plumber to install a dual-outlet garden tap by teeing off the cold water line located beside my heat pump hot water system. Job Details: • Existing power point and water line already accessible next to the hot water unit. • Short pipe run (approx. 0.5–1 m) to new tap location. • Include a ball valve shut-off for isolation and ensure a neat, secure installation. • The property already has a main backflow prevention device (bidets installed in all toilets), so additional backflow prevention at this tap is not required. • Tap will supply a hydroponic vertical garden (permanently connected) and general garden hose use. • All fittings, pipework, and a solid brass dual outlet tap to be supplied and installed by the plumber. • Ensure the work meets AS/NZS 3500 compliance standards and provide a Certificate of Compliance after completion. • Ground-level access, clear workspace, and close proximity to the existing plumbing line. • No wall chasing or complex routing expected. Site Conditions: • Fully accessible outdoor area. • Power and water available at the location. • Concrete base beside hot water unit with wall for tap mounting.

I need to move the compressor of a hot water system (heat pump)

We have our own Samsung heat pump clothes dryer sitting in our balcony. Our rental apartment came with its own tumble dryer suspended on the wall. We want to remove the existing dryer and fix our dryer in the same position. Thanks

Ecogenica model Eg-215f, Failed capacitor or tripped safety switch issue. 15mm tempering valve has been replaced same issue. Recall for where the control panel inside the heat pump unit hasn't been touched just out of warranty 2yrs & 3 months now. Warranty 2 yrs. Need quote on repairs. Thanks in advance. Not a emergency situation.

Relocate the installed pool heat pump around the corner so it is in the small alley instead. Will need to prep and level ground, supply pvc pipes/connectors etc and be capable of removing piping that is connected with a pvc solvent without damaging other hardware

Dryer pump needs to be replaced- not pumping out water

Install the new heat pump. This is the old heat pump. Give your best quote

Samsung Heat Pump Tumble Dryer: thoroughly cleaning the heat exchanger elements, Full disassembly required - see https://www.youtube.com/watch?v=lAG0XIX5i8U&t=732s Model DV90M50003X/EU 9KG Samsung Optimal Dry 8kg Heat pump tumble dryer

Need a Qualified Plumber to fix leaking water Heat Pump.

My hot water (Heat Pump) is not working.The Hot water switch is tripping off. Not sure if it is related to circuit issue or Hot water Element issue. Hence, looking for sparky who also has an idea about hot water system (Heat Pump). If you do not charge call out fee to check the issue, please let me know.

I need plumber to certify heat pump installation ongoing opportunity urgent ! Any questions please ask available for full assistance

Looking to replace an existing gas tank with heat pump. Show me what you have for the budget. 270L tank, electricity box is 4m from tank on same wall.

I need to swap electrical hot water system to a heat pump system.

Our Samsung Heat Pump Dryer is not spinning properly. The motor hums but it won’t spin. We found that the motor shaft is sitting too low as it is rubbing on the bottom, disabling the drum from spinning properly. This needs to be raised a little higher (see picture attached). Please let us know if you have experience with this. We need this done ASAP.

quote on a heat pump water system supplied and install size of water pump should be at least 320lts