Find an experienced handyman in Kingsgrove

I have purchased a door that needs to be measured against a frame that is already in place and hinges that are already on the frame. The door needs to be cut to size, including installing the lock mechanism.

Please send through your quote The garage roller door has been bumped and now has a dent near the bottom. It still opens, but stops about 50 cm from the door bottm because the damaged section catches on the outside timber frame. Site inspection is welcome for an accurant quote Scope of Work 1. Straighten the door panel and the bottom section (as shown in the photos) so the door can fully roll up again.

Assemble two flat packs, put hooks up, blow backyards clean, fix fly screen, Need your own drill, we have blower available. We have all resources such a fly screen and screws.

My glass slide door has abit of crack on it and want it to be fix asap

Recently installed villaboard walls need setting and get prepared for painting. Also a couple of damage in gyprock needs to be fixed.

Looking to supply and install basic ceiling fan with switch. No fan on existing ceiling

Glass sliding door rollers need replacing & door handle

Install an awning (1m x 1m) fibreglass screen on a hebel wall outside. Attach a photo of the wall where the awning was (putty) and a photo of another awning elsewhere. Anchor 40mm long, screw 4mm diameter. Maybe need a wider screw, slightly longer anchor ?50-60mm (ramset screw plug). Install the awning lower below the light this time, less likely to be blown off by the wind.

My shutter doesn’t open up it is operate by a winch system and it goes to open but it gets caught on something

4 X concept 2 rowers 4 X concept 2 ski erg 4 X concept 2 bike erg One of the handles on one ski erg has come undone and also needs repair Maintenance includes calibration and cleaning of internals of the machines

So what we need is: - small patch ups and paint work , might need a very small bit of gyprock - ⁠drilling of 4 hooks (once paint has been done) - ⁠laquer on timber frame structure on deck (to protect from sun damage)

Replace screws on 2 sash fastener window locks, source and refit new fastener fly screen clasps to two windows. Repair fly screens to 2 panels of Queenslander type room. Source screen netting.

Gyprok drop ceiling 4.3 by 5.5 can supply gyprok channels

https://www.ikea.com/au/en/p/vidga-two-track-wall-set-white-s49428265/ installation of IKEA curtain tracks . on 4 windows + hanging 2 x https://www.ikea.com/au/en/p/dignitet-curtain-wire-stainless-steel-30172797/. Job will take no longer than 4 hrs . House double brick wall . The potential for more similar jobs

I have a kitchen pantry that currently has hanging shelves. I want this removed and new kitchen shelves and cupboards installed.

When I slide it a little bit, the roller comes off the track. Inspection shows that the bottom track is dented / slightly collapsed, causing the wheel to jump out of the rail. I need someone experienced with sliding door repairs to: Repair the bottom track (track cap, etc) Check and replace rollers if needed Reinstall and adjust the door so it slides smoothly Provide materials Please bring tools. Door is aluminium frame.

Removing an old tap and installing a new one.

Clean wall mounted fans (3m high) Paint 1 roof and 3 walls Assemble 2 floor fans Put up a hook in bathroom Put up a hook on wall and tighten a hook on wall

Repair 2 window to move up/down and 2 internal door not closing

The mirrored sliding doors in our built in wardrobes (3) are not running smoothly.