Find an experienced fireplace installation professional in Coburg

Tiling fireplace We have tiles ready to go Dimensions of fireplace are below: 1.68wide x 1.0high x 0.1deep Cut out section is 0.64 x 0.64

Need an electric fireplace installed in existing mantle. Some structural work is required. Existing mantle is art deco material plaster. - Due date: Flexible

I have an old Braemar WF2000 space heater (not working) that I'm looking to have removed and replaced with a freestanding gas fireplace. It's a two storey unit (requiring a hole be cut in the floor/ceiling for the flue) and I believe the flue would go through the wardrobe space in the photos so I am also looking for someone who can remove the shelving in the cupboard space and clear it for the flue. While I do have a 3.6m flue kit, it will require an extension to go through the second story and possibly a bend to divert it into the right position upstairs so it would be great if you could supply the required flue parts. - Due date: Flexible

Painting two bedroom walls. Fire place (small) and top/side wardrobes. Not doors 3m height. Walls have been primed. 2 coats Need to supply equipment and drop sheets. Paint provide by me. - Due date:today or tomorrow

I have another trim that’s a little bit to big , it needs to be trimmed in size and l would like it to be power coated in black - Due date: Flexible

We need an old fireplace sealed up after removing a gas heater. It looks like the bricks were removed from the hearth so it's mostly bare earth. Need to seal that up with either concrete or brick and cover old fireplace with sheeting: - Seal up hole (apx 10cm) in brickwork where gas vented to outside. - Brick or concrete over old hearth (bricks have been removed so hearth is currently bare earth) - Board up unused fireplace using plaster or FC. - Repair/remove old concrete in front of the fireplace and level off to floorboard level. - Due date: Needs to be done on Monday, 24 October 2022

Need a certified plumber to make sure we're purchasing the right wood heater and flue and then install. The existing masonry fireplace has a power and gas connection from an old gas heater so also need advice on what we do with the gas termination to make it safe. Link to Wood heater - https://www.barbequesgalore.com.au/p/nomad-insert/MXNOIN19K.html - Due date: Flexible

Need to fit a wood fire heater. the heater flue needs to be installed through the roof. a mechanical plumber would be ideal. - Due date: Flexible

Needing someone to re-tile and re-brick a hole left by previous owners (DIY hole for gas/electricity heater. Might be tricky as there is no base, only the fireplace bricks. Will also need to remove/reposition the gas pipe (has been capped) and electricity cables away from the fireplace, which are under the house. Tiles and bricks have already been purchased. Thanks.

Two fireplaces in a federation cottage requiring restoration, including tiling, plastering, installation of grates, fascias and mantels - Due date: Flexible

I need to get an electrical cable to the back of a fireplace ahead of a plumber installing a gas fire. I need a cable with fan base wired from the back of the fireplace to a power switch on the wall to the side of the fire place. We have the switch plate with the third switch but need you to put the cable through the brick wall or down under the house and back up through the floor into the cavity. See photos attatched

Would like to organise and a Gas Fireplace Inspection and Service

We have the 1410 fireplace and require a fireplace installer. Must be experienced. We have the fireplace and will supply all equipment.

We have s small brick fireplace and would like only the inside of it sandbagged in a grey colour called bluestone.