50 Blueboard Installers in SA

Cover existing fence with a blue board fence. Making the fence line higher for privacy.

Installation of 80m2 of blue board cladding to external house extension. Blue board supplied. Does not need rendering.

Blue board bottom edge and a little on the side needs to be refixed to the studs and a couple of small cracks. All on the second story and all walls are rendered.

Install blueboard to new garage. Qualified carpenter

I am looking for someone who can do a rendering work to come and work on my wall blue board (Rendering it to look the same with the wall of the house) I attached the picture here!

I need to have a blue board external fence built. The fence will be 2100mm high and roughly 14 panels long (each panel is 1200mm wide). The job entails building a wooden fame between pre existing 100mm x 100mm square posts, fitting blue board on one side, flushing the joints and fitting fibre cement lattice on the other side. Framing can be a one man job but fitting the board is a two man job. only apply if you have worked with timber framing and blue board

Install blue board on one side of the pergola between the posts

Morning, Looking for someone who can screw blueboard to a fence. I have 3 2440w x 1000h blueboards that need to be screwed into my fence. Need it done today. Thanks

We are trying to finish of some renovations to the house and need some more blueboard cut to size to frame outs our exterior windows prior to rendering. I have timber and blueboard but haven't cut it myself before. There are three window areas to prepare. Should just require timber frame and nail in however one looks tricky

blueboard installation over coorbond fence

Screw in and paint some blue board that is about 2.5 by 4M

Howdy. I have 2 holes in a brick wall (that used to be a gas heater) which I need covered with blueboard. The hole is about 620 x 910, but the blueboard will need to be about 1200 high and wide (approx). Will need to be measured and cut on site. See attached pic. I would do it but I have no tools. The blueboard will need to be fixed to the wall. If it can be done tomorrow, that's great. If not, Monday next week.

I have 3 x blueboard sheets 2440 x 1200h & need it cut to measure 1000h

due to termite damage i need to do some repairs. I need to rebuild 2 walls that were the walls of the verandah. it was previously a bedroom. blueboard the outside and gyprock the inside. the floor also needs to be rebuilt or concrete laid then tiled. i can help if needed.