Find a local floorboard profesional in Inner South West Sydney

We have a couple minor burns on 2 laminate floorboard planks and we need them replaced. We have the spare flooring, however, will have to be cut to match length of floorboards being replaced.

Need a professional floor installer to replace damaged engineering timber floor boards for home (glue down installed)

Need floor boards repaired. Fill sand back stain and polisg these 3 areas

Where the dining room and kitchen intersect, the doorway has been widened and the floor section needs to be fixed with floor boards to match. 2 floor boards lengths to be removed and the entire length to then be replaced. Matching Floor boards provided. Concrete will be lowered so floor boards can be installed. Area measures 2250 x 200mm Bedroom has had a fireplace removed. Concrete as been lowered already and ready for floorboard installation. Floorboards will need to be cut to be installed, no existing floor boards to be removed. Area Measured 1710mm x 470mm

My house has hybrid flooring, and the heat damages it. I need some to replace a few panels of the floor board

We need to install approx 50m of new skirting boards in our 2 bed apartment after we install new floorboards

I would like my carpet to be changed into floorboards in the entrance area. The area from the widest and longest points are approx 3m by 3.5m with many doors Boards are not ready yet just wanting to sort out before hand ** The floor Will be prepped before hand with all carpet removed and everything cleaned and sealed ** Floorboards are supplied as they need to match living room please don't quote me for floorboards

Installation of vinyl or floor boards for a kitchen in surryhills installation above existing vinyl Roughly 3x2

We’re looking for an experienced flooring specialist or carpenter to inspect and repair a sinking section in our dining room floor. The current floor is laminate glued over existing timber floorboards. The area noticeably sinks or flexes when walked on, suggesting there may be an issue with support timbers, subfloor, or joists underneath. What’s required: • Inspect and diagnose the cause of the floor sinking • Carefully remove the laminate in the affected area • Repair or reinforce the subfloor/timber support • Reinstall the existing laminate (or source and replace with matching boards if damaged or not reusable) Location: [Insert your suburb] Preferred time: Flexible – weekdays or weekends Please only respond if you have experience with timber subfloors and laminate installation. Include your quote or hourly rate and examples of similar repair work if available.

Small burn marks on timber floorboards in rental apartment. Need spot repair - sanding, filling, staining to match, and refinishing. Approximately 15-20 cm long

Remove and replace skirting board in 3.5 x 3.8m room

Repair squeaky floorboards

I need someone to lay floor boards in one of the rooms in my house approximately 11 square meter room will rip up carpet prior to you comming and will supply underlay and floorboards

install floorboards to bedroom Only small room

Exposed floorboards in the corner of a room need to be covered by new floorboard. Floorboards and skirting board need to be cut to size. All floorboards and skirting boards need to be cut to the appropriate size (we don’t have the tools to do this)

The floor in my sunroom needs to be raised slightly so that I can lay floorboards. There are curves where the wall meets the floor which mean I can’t lay floorboards until it is raised a couple of centimetres and the angle is square/ level

Looking for someone who can purchase floor direct from supplier and lay. One bedroom only - room size is 13 m2. Current carpet will need to be removed 12mm Oakleaf Laminate Seashell 2200x193x12mm

Remove marks and small dent on floor board

I’d like to replace the skirting boards in my home. Location is Monterey. Approx 106 lineal metres.

We have a few Floating floorboards that have lifted. Photos don’t do it justice unfort. We’d like someone to come out to suggest what can be done without replacing the whole lot. Thanks in advance ☺️