Find experienced local fencing contractors in SA

I need an experienced landscaper/fencer: to Repair 2 large panels (6sheets)to an old good neighbor fence. Install a Spear security type fence about 10 meter including a manual sliding gate 4 meters and a 1 meter pedestrian gate out the front. Also a small approx. 4mx4m leveling off with an excavator will be needed to my garden area. Depending on the outcome there could be more gardening work needed - installation of fake turf and pebbles.

Toxic spray was put on the bushes and I need some temp fence to stop my dog from getting to it. :(

Erect colorbond fence around my new home

Attach 2 x bamboo garden gates to poles

Hey there - my garden gate got misaligned over the time - I struggle to close it. Need someone to align the gate & fix up Make me an offer Need this done asap

Garden wooden fences are loose and damaged , need repair and reinforcement

Garden gate dropped a bit on one side and making it difficult to open and close

I am looking for quotes to install a rendered boundary wall at my property. Either blueboard or brick depending on price. "Budget" on this ad is not actual budget, as I dont have much idea of how much it will cost, hence requesting quotes. Approximately 27 lineal metres, 2m height (red line on image below). Will need letter box built in, and approx 1.8m area where gate will go (blue line; I am unsure how to finish this section over existing concrete path).

Side gate latch and hinges were damaged by strong winds and need fixing.

I’m looking for someone to build a garden fence (just the wooden part), similar to the one shown in the attached picture. The fence will have 3 sides, and the measurements 6M each. Will supply all the materials required

We have just moved into a new house and the developer did not replace the old fence at the back of the property. It’s a shared fence with a neighbour directly behind. We have discussed with them that we will clean and spray paint it to match the side fence. Please quote me for this - fence is 9m long, about 1.6m high. Thanks.

Looking for a fence installer to do my garden's fencing. I want the fence height around 1 - 1.2m. I also need some advice on if I should only do one side (around 10.5 meters)'s fence or two sides (around 10.5m x 7m) etc. etc. Material requirement: aluminum slat. Thank you.

Install a Garden Gate To access from the side

To be installed already purchased garden gate, the existing fence posts are solid, the gap between the posts is 840cm, the gate is 900cm w an A1 protector aluminum flat top pool gate. I'm hoping to retain the existing post and mount the gate on the outside of the posts. I can purchase the hinges and D-latch you recommend or if you can provide.

Just after a side garden gate, approx 1 metre in length and 1 metre high. I’ve attached an example of the type of gate I’d want. There is concrete covering 1/3 of the ground with dirt on 1/3 so I’m unsure how it will need to be secured. Happy to supply more pics of the area if needed.

I need a small gate 920x 120 CMS installed in a section of my garden.

Fix / replace hinges of side garden colorbond gate (destroyed by strong winds) and reattach the gate. Replace gate latch with a new one similar to the old one. Images are uploaded here.

Install post in ground and hose reel

Needing someone to install a gate separating our garden from the front gate on a good neighbour fence to keep the dogs out. Unsure on what Is a reasonable price. - Due date: Flexible

We and our neighbour's are replacing about 10 meters of fencing. There is a query, but no conflict about the fence line - Due date: Flexible

Oscillot cat fence Roller required to be installed. Small backyard (10 Meter)

Need an existing post and rail fence moved closer to the boundary line between two properties. Able to reuse existing sheets and rails as fence is only 4 years old. Approximately 25m in length

Need compliance certificate asap but gate spring is detatched and post next to it is broken so needs to be fixex or replaced. Hoping to get certificate on same day for my conveyancer.

Build a new fence. Length 3.6 m height 1.5 m . To partition dogs from the back

There is a small gap under my gate that my dog can squeeze under. I need it fixed so he's no longer Houdini.

I need someone to fabricate and install some front gates. Gates should not be able to be seen through. Was thinking galvanised frame and colour bond panels but open to options. The supporting posts are installed. Will update with measurements soon.

old front brush fence approx 10m by 3m L shape, remove and dispose of all brush fencing, and posts - ready for new fence Concrete at bottom removed also

Quote for a tubular fence to enclose an area

Need a gate to fence off an area for my dog, roughly 1100-1200mm high - 6m long. One end is against bricks and the other is against a fence or a wooden post Happy to provide fence can talk about it after

Hoping someone “handy” can come up with a budget friendly solution to dog proof the bottom section of my fence (it’s a rental). Needs to be aesthetically pleasing also. It’s about 8m long and approx. 15cm gap underneath. Will pay for whatever is needed from Bunnings etc plus your time. I need done ASAP as we can’t use the front yard until it’s secured. I’ve entered a nominal amount in the budget area until we have a better idea of options. Task needs to be undertaken after 12pm. Cheers

I need someone to go and take a look at a dog trailer that's sitting in my friends driveway to see what needs to be repaired on it so that it can be towed back to my place in Campbelltown. I would then like that same person to do the repairs and the towing back in the following days but this task is just to go and look and see, we will sort out the rest once we have connected :) It is a 4 berth dog trailer and unfortunately i don't have a photo of it. I believe that all that is wrong with it is it has a flat tyre that will need replacing

Hi, looking for a surveyor that is able to identify boundary locations for installation of new boundary fences. Located Redwood park

Build a fence to enclose part of yard for 2 dogs

To install a pet gate between a brick house and colour bond fence.

it'll be two sides as the other two side are my house. One side to be 6.4 meters in length and the other side to be 7.4 meters in length. They hight of it should be 4 foot - ish. One side must have a gate. - Due date: Before Monday, 19 February 2024

Fence to contain dogs and not obstruct the view of the surrounding property. about 16m x 13m - Due date: Flexible

2500 mm fence 1300mm high to stop dogs jumping at neighbours fence as they have cats are are annoying neighbour fence if possible house to metal fence long If possible have fence longer and completely block path to fence 1m out - Due date: Before Sunday, 15 October 2023

A fence that can keep a small dog in (spoodle, will grow to be 40cm heigh and 7-10kg). He has just jumped out of a 80cm heigh temporary fence i have currently, so will need to be 1.2-1.5m heigh, very stable and have a gate. Ideally i would like it to be black and see through but open to solid forms if it will keep him in my small back yard area. - Due date: Flexible

Hi I need 9 temporary fence panels and 7 concrete feet picked up from modbury north and dropped off in Warradale. Panels are 2.4m by 2.1m a workmate is usually okay to transport these. - Due date: Flexible

I’m looking to get a quotation for the backyard fence (Mandorla Boulevard, Munno Para Downs, 5115). Its about 12.51 meters long. One side of the property has already been completed, and my neighbour on the left has organised the other side, so I’m just getting a few quotes for the rear fence and side gate in the quote please Measurement for side gate space: 1.36 meters Would you be able to provide a quote? (attached image is of the side thats been done already) *Quote should include material and labour *

Material will be supplied and on the land OR quote for supply and install

Install 17 Screenline colourbond fence extension panels that are 300 mm tall. We have trees in sections, so you will need to access those sections of fence through the neighbour’s side, which we have approval for.

Looking for someone to supply and install a basic solid Colorbond pedestrian gate in the side passage shown in the photos. The gate color has to be cream rather than grey (as depicted in the ai image) I’m looking for a simple and affordable solution, not a decorative or premium custom gate. Requirements: Solid Colorbond for privacy Basic gate frame, hinges and latch Gate roughly matching the height of the existing fence Open to installation of a used gate / fencing materials Supply and installation included Please measure on site and recommend the simplest practical installation. Please quote total price including materials and labour.

Supply & Install 2 gates and a colourbond frame. See specifications

Supply & Install Colorbond Fence (~23m–26m Straight Line) + Removal Please provide a written quote detailing: ​ ​Supply & installation labour cost per metre. ​Availability and estimated project start date.

Existing gate to be modified - needs to swing opposite way and have a pool type latch installed and existing removed.

One of my fence colorbond fence panels has been damaged. Looking to replace the one damaged panel and straighten up the fence.

measure and quote for a approximately 30 meter Colourbond fence

Supply and install 15 meter colour bond fence

we need 25 metres of colorbond good neighbour fencing installed 1800mm high with concrete plinths. Removal of old fence

Supply and build Colourbond Fencing. 5m x 1.5m

EXPERIENCED HANDYMAN OR FENCER REQUIRED TO FILL AN APPROXIMATE 60MM GAP BETWEEN THE OLD EXISTING FENCE 1750MM HIGH AND THE NEW FENCE. I HAVE COLORBOND SHEET MATCHING THE EXISTING FENCE OF WHICH COULD POSSIBLY BE CUT AND OVERLAPPED AND SCREWED TO EXISTING RAIL. I AM LOOKING TO DO AS EFFICIENTLY AS POSSIBLE, IDEAS WELCOME

Install roll of brush fencing to colourbond fence Use new c section bottom rail and wire

Supply and install colorbond single gate with powder coated posts and gate frame 1100mm width 1500mm height

We require 3 Latrice Plastic Diamond Matrix 2410 x 1205 x 7 MM trellis panels to be screwed or riveted to our good neighbour colour bond fence. Each panel is to be placed 2410 upright and width 1205 MM. purpose is to screen a bank of our neighbours solar batteries from our view.

Fence needs 2 colourbond sheets and fixed

Partial fence removal and discarding of it, There’s a marking on the fence already.

I’ve got a few days work for a suitably experienced fencing contractor in Lockleys. The job involves alterations to an existing fence to install concrete sleepers below. I will be doing the retaining part of it but need help with the fencing.

Removal of brushed fence and installation of colourbond fence.