Find a fence installation professional in Logan Beaudesert

Hi All, I have x2 wooden fence/gates that i need replaced as they are old and falling apart. I’d like both fence gates to swing open for access. The measurements are as followed: 1. w250cm x h185cm 2. w290cm x h150com - i’d like the height of this gate to be increased to 2metres if possible I would need materials supplied and removal of the old fence as part of the quote/offer Thank you for your help

I need a fence built to put into my rental property to keep my dog inside. Not too expensive.

Looking for a gate installer to supply and install a new pedestrian side gate at my property in Greenbank 4124. The gap between the fence and house wall is approximately 1.5m wide. Fence height is 1.8m.

Need to install a glass pool fence about 5m and a aluminium gate between the house and side fence

(Driveway gate install ) I have gate need a handyman for installed

Please provide a quote for a 1.5m high pvc fence. One side is 9m the other side is 3m. L shaped fence line. Please provide the cheapest fence type option

2 fence gates cannot be closed as they are rubbing at the bottom concrete.

I am needing quotes for pool gate to be installed

We need a contractor who has experience in installation of Colorbond fence and aluminium batten security/driveway gate

Looking for someone who can install 2 picket gates. Have already got one of the gates. Gate 1: Height 1.8m width 1 meter Have already got a gate of 1.8x0.9m Gate 2: Height 1.8m Width 0.7 Need a gate

Fence Post has rotted out at bottom and needs replacement. This is a support for the colourbond fence. Exact Job: Remove adjacent pavers to existing 3 Colourbond posts. approximately 250 x 250 area. Ground will need to be excavated approximately 600mm for new post to be installed. New 100 x 75 mm H4 posts to be installed in holes, plumbed up and concreted in. Trowel finish at base of posts to fill in missing pavers. Cut down appropriate lengths of galvanised threaded rod. drill 2 holes in timber post and existing colour bond post ( top and approximately 600mm up from ground.) Utilising m12 nuts and 50 x 50 galvanised washers. Bolt/washer either side of post, followed by plumbing up fence then using the same method nuts/washer to clamp in place.

I need a pool gate made & installed quotes please

Installation of glass pool fence onto tiles. Have everything needed already for the fence. Roughly 5 metres long.

I have a colorbond boundary fence. I have recently had some renovations done and need access to backyard so I removed 2x fence panels and 1x centre post. I need the colorbond post replaced and reinstalled. I still have the rails and old colorbond sheets so they will not need replacing just to be reinstalled.

Pool gate bar been damaged by trespassing, replacement required

Two small side fences Fence one approximately 4 m x 1 m high Fence two approximately 4 m x 1.5 m Easy access easy digging

Looking for an experienced fencing contractor. Details: 7m long fence 1.1m height 1.1m wide gate 3 posts Scope: Supply and install hardwood timber slats and posts, outdoor-rated screws, oil or stain finish, and labour included. Please arrange site inspection and provide quote, timeframe, and confirmation of insurance.

Looking to get colorbond fence and electric gate supplied and installed in my front yard, also old fence removed. Pic attached for reference of measurements

I am looking for someone to remove and dispose of existing wire/timber fence, and to then supply (pick up) and install new pool fence with gate (approx 7.5m) into concrete slab. Existing timber fence - this is easy to remove - needs posts to be cut at slab level and wire snipped. New fence - will join existing pool fence section and will go into concrete slab. Access to property is very good and I’d be happy to assist if needed. I’ll pay for the materials separately - the cost here is for your labour and disposal of old fence.

Hi! I need a pillar-style mailbox installed into my wooden fence, plus removal of the old mailbox (it’s already loose). Job Includes: - Removing the old mailbox - Cutting the fence to fit the new pillar-style mailbox - adding necessary support framing or a small post so the cut fence section is secure - Installing and securing the new mailbox/pillar - Pouring a small concrete footing for stability - Supplying all materials needed (concrete mix, brackets, screws, fixings) - Cleaning up afterwards I Will Provide: - The new mailbox/pillar unit Access: Very easy suburban front yard. No masonry required. Timing: Flexible - item hasn't arrived yet so sometime next week! I've attached a photo of what I bought and my current fence/property. Height: 1000 Length: 380 Width: 365