Find trusted amplifier repair experts near you

I need an 8 Gauge wire directly hardwired to the 12v + on the Sony Xplod Amplifier Circuit Board

I have a pionner vsx- d2011 home amplifier. It was working but the audio stopped. I have tried to do a factory reset but unable to set up the amplifier again. I am needing someone who knows about setting up home amplifiers to come and set it up. Please quote.

I have a VOC VT20X guitar amp that no longer powers on. I imagine it's a simple fix.

My the BOSE amplifier in my Mazda 3 SP20 has started making a banging/popping sound which is a known common issue with this amplifier. Will need the amplifier taken out repaired and put back in.

Installation of Subwoofer and Amplifier into new car 2021 Ford Everest will be using current head unit. Sub and Amp already in box. Taken out of old car no wiring or cables unfortunately.

Needing auto electrician to fix my pioneer surround sound amplifier system at my house

Alpine 4 channel 445u power pack amp to be installed in a 2015 Mazda 3 with factory non Bose head unit

all dials were cleaned with contact cleaner, as the music dial was up and down now it plays at full vol and clarity, but the mike circuit is not amplifying properly

One of the speaker channels has stopped working on my Sansai solid state stereo amplifier AU-555A

I have a 1970s Onkyo X-3 4-Channel Surround Stereo System (integrated amp/receiver) that produces a loud, low-frequency hum when powered on. Hum is constant and unaffected by any front panel control (volume, bass, treble, balance, etc.) Hum remains identical regardless of which input is selected (Phono, Tape, FM, AUX) No cables are plugged into any RCA inputs — hum persists even with nothing connected Likely the aging electrolytic capacitors in the power supply that needs a recap though I'd welcome a proper diagnosis from someone experienced with vintage hi-fi equipment.

I have a Meyer sound plate amplifier that has a nasty buzz whenever anything is plugged into the input. Assuming failed component on preamplifier board

Hi, I replaced the amplifier in my 2012 Skoda Superb, but there is still no sound from the speakers. After diagnosis, it shows that the amplifier has gone into anti-theft / component protection mode. Please check and perform: * Component protection removal * Amplifier coding/adaptation to the vehicle * MOST/fiber optic communication check if required Current issue: * Radio powers on normally * No audio output from speakers

Amplifier receiver loses volume

I cannot connect Project turntable to Yamaha Musiccast receiver

Install head unit and speakers

I’ve got a 2008 Subaru hatch. I’ve got the following setup • Alpine iLX-F509A • R2-S65C fronts • R2-S65 rears • Two PWE-S8 powered subs I just bought a new pioneer GM-D8704so I need help installing the amp. I don’t have the wires so I’ll get that from you as well if possible I’m located in rowville At the moment as well, I do have the subs installed under the boot liner thinking it would sound good but still look oem, but should have just popped them under the seat like they should have, so I was hoping to get that done as well.

Connect speakers & turntable to Maranz amplifier & confirm working correctly. NB - this is not bluetooth but a traditional system.

Run two cables through the wall (probably different routes) from home entertainment system to rear speaker

Sony amp no longer getting video signal after swapping HDMI connection and new TV . Also have a back haul mesh network thstbibwiuld line someone to look at .

Error message on amplifier NG:LCRSLSRBLBR, have tried a factory reset to no avail. Might need to replaced the two fuses located at rear of amplifier