Find trusted local electricians in Quakers Hill

I have a small 1-BHK studio located at my property in Blacktown. Studio is still under renovation. Currently, the studio is powered from the main house electricity meter, and I want to separate the electricity usage for the studio. Existing Setup • Main house has a 3-phase electricity meter • One phase can be allocated for the studio Studio Electrical Load Includes • 10 × downlights • 10 × power points • 1 × oven • 1 × cooktop • 1 × split system air conditioner Scope of Work • Allocate one phase from the existing 3-phase supply • Install a separate sub-meter (reading meter) for the studio • Rewire / redirect the studio circuits to the new sub-meter • Ensure installation is AS compliant • Testing, labelling, and safety checks • Provide Certificate of Compliance (CoC) No separate Ausgrid meter required — but would appreciate if you can let me know how much additional this will cost Requirements • Must provide license number and CoC • Experience with sub-meters and 3-phase systems Budget Around $2,000 Happy to arrange a site visit if required.

- New Power plug Socket to install in bed room (socket to be provided by me) - New network sockets to be installed in bedroom and kitchen with running cable between them (cable and sockets to be provided by me) - distance in less than 8 meters inside the roof - replace 3-in-1 shower fan heater unit (material to be provider by me) - replace one fault RCBO in electricity box (material to be provided by me)

I need help to install/solder 33 inches light strip as existing one has stopped working

I just added another GPO for microwave behind kitchen carcass, can you please update your price? Please refer to the last photo for this GPO A quote is required for the following works: • Remove existing 4 light switches and supply and install four (4) new light switches (non-dimmable). • Remove TWO (2) existing GPO and supply and install TWO (2) new GPO of the same type. • Remove one (1) existing wall light and only install the new white wall light shown in the photo. White wall light is supplied by others.

I need birdmesh installed for 13 solar panels on the roof. Bird mesh available at site

20 new down lights to be installed in 4 rooms($15 per light), 4 fans to be replaced($30 per fan), 1 flat ceiling light installed($30), 2 wall switches replaced ($15per switch). We will be supplying all the material. Kindly refrain from rudeness, if it doesn't suit you please ignore. Thanks

mesh for keeping birds from solar panels

My HVAC indoor controller is not working and display is off. The outdoor unit is running and the ducts are blowing air

The ceiling fan in the bedroom is non functional. I want it to be looked at and uninstall to send it for warranty. Move the outdoor power point to lower position next to the water tank. Thanks

Electrical to outdoor office - above ground conduit from power box

Looking to move my security system NBN box through the room right next door

I want to separate my 3 phase aircon circuit breaker permanently to draw from the grid and not from the battery because my solar battery is getting drained twice a day. I have a 3 phase battery.

Replace the existing electrical meter box with a new compliant meter box. This includes removal of the old meter box, installation of the new enclosure, upgrading or adjusting wiring as required to meet current Australian safety standards. Additionally, carry out backyard lighting works, including installation of new light fittings, associated wiring and switching,

Electrical issues with bear

Accidently spayed water on water on wall light button

solar panels require meshing to prevent pigeons from nesting. need to replace whirly bird

Our electricity bill has been unusually high for the past few months. We suspect the issue is with our outdoor hot water tank (installed about 6 months ago). The thermostat/temperature setting might be incorrect and could be causing the heater to run constantly. We need a qualified plumber to: • Check the hot water tank • Inspect the thermostat/temperature setting • Reset it to the correct safe and efficient setting • Make sure everything is working normally There is no major repair expected — just checking and adjusting the temperature setting.

Our centralised ducted air conditioning system has stopped working since last year. The green light shows on the unit, but the AC does not turn on or produce any airflow. We need an experienced AC technician to: • Inspect and diagnose the issue • Provide advice and fix the system Looking for someone reliable with experience in ducted AC systems.

1. Remove the old aircon as images attached, it's installed as back to back 2. Install new 2.5KW aircon, we will buy it

Ac remote not working. Seems like the eye of ac is not k