Find trusted local electricians in Outer West Sydney

Looking for a licensed electrician familiar with Sigenergy and Shelly products. 1. I would like a Shelly Pro 4PM installed and integrated with my Sigenergy so the following loads can be controlled separately via mySigen/Home Assistant: - Hot water system (3.6kW) - Pool pump/chlorinator - Pool solar heater - Air conditioner (2.7kW) 2. Also require the installation/replacement of 5 additional wall switches/GPOs. I have the switches/GPOs. Happy for an on-site inspection and quote, if required.

My bathroom switch broke last night and needs repairing. I live in an apartment building level one

Looking to update/replace existing light/power points in our home 3x ceiling fan/light switches 3 double power points( 1 to have USB ports) 4x single light switches 4x double light switches 2x triple light switches 1x double power point with 2 light switches on the same unit ( not sure if this is achievable) this is the last photo How much would labour be if we supplied the fittings ? How much for you to supply & fit the fittings ?

Remove exisiting 3kw solar panel system.

Outside PowerPoint has been chewed by dog, damage is cosmetic everything still works but need to replace the PowerPoint to ensure we get our bond back. Have the replacement unit just need it installed properly

I need a qualified installer to remove an old Toshiba wall air conditioner and install a new reverse‑cycle window/wall unit in the same spot. Opening size: • Width: ~510 mm • Height: ~335 mm • Wall: (brick/gyprock – installer to confirm on inspection) The new unit will be a compact reverse‑cycle model (Kelvinator/Teco 2.2 kW). These units are slightly taller (around 345 mm), so the job may require: • Minor height trim (1–2 cm) OR • Lowering the opening slightly OR • A small timber infill panel I want the installer to advise the best option.

I am looking for a licensed NSW Level 2 Accredited Service Provider (ASP) electrician to upgrade my residential electricity supply from single-phase to three-phase at my home in St Marys, NSW 2760. Existing Setup - Three service fuse positions are already installed in the meter box. - Only one service fuse is currently connected. - There is sufficient space in the existing meter box. - The current electricity meter is an older non-smart meter. - The property is supplied by Endeavour Energy. - My electricity retailer is AGL. Scope of Work Please provide a fixed-price quote covering all labour, materials and compliance costs required to: - Inspect the existing installation and confirm suitability for three-phase supply. - Complete and submit all required applications and paperwork. - Upgrade the service connection from single-phase to three-phase. - Install and connect all three service fuses. - Carry out any necessary switchboard modifications within the existing meter box. - Balance existing circuits across the three phases. - Test and commission the installation. - Provide a Certificate of Compliance for Electrical Work (CCEW). Pricing Requirements Your quote should include: - All labour costs - All materials and equipment - Application and administrative fees - Testing and certification - Airtasker fees (if applicable) Your quote should exclude: - Any charges billed directly by Endeavour Energy - Any metering or related charges billed directly by AGL Contractor Requirements - Current NSW electrical licence - NSW Level 2 ASP accreditation - Public liability insurance - Experience with residential three-phase upgrades Additional Information Please indicate: - Whether a site inspection is required before providing a final quote - Estimated timeframe to complete the work - Any assumptions or exclusions Please provide your total fixed price (excluding Endeavour Energy and AGL charges) and a brief summary of your relevant experience.

I have 23 solar panels. I would like them inspected along with the inverter. I believe there may be issues with some of the solar panels.

New fibreglass pool install need electrical done - 2 double power points - 1 hard wire single phase 19kw heat pump -earthing to pool - wire a submersible pump next to pool

Change downlighting in living room Some lights don’t work at all, not just replacement of bulb.

The power cord for the down light got disconnected/unplugged from the PowerPoint in the roof. We just need you to climb into the roof to reconnect it

Disconnect and bring solar panels down off the roof.

Looking for a licensed electrician to install a weatherproof outdoor power point on the front porch of my house in Hazelbrook, for charging an electric vehicle.

G'day guys, I'm after someone that can install a outdoor water proof double power point next to a meter box. This will be a new connection as well. I'll supply the required power point. This task is for the labour and the required connections to install it. I have no idea of costing.

I have a downlight that is flickering in my lounge room no problem to swap it out with a less used one unless a handyman can identify this light to buy think it’s fairly generic

I want to get two outdoor waterproof power points and one indoor power point for tv, at my home in Cranebrook. I have attached photos showing the wall

Hello, We are looking for a licensed electrician or a skilled handyman to adjust the height of three pendant lights at our retail store, in Westfield Penrith. The Issue: The three large, black dome pendant lights hanging over our main display table are not level with each other. The Job: The task is to professionally adjust the suspension cables of the three pendant lights so they all hang at the exact same height. The scope of work includes: 1. Safely accessing the high ceiling mounts for each of the three lights (a suitable ladder is required). 2. Carefully adjusting the length of the suspension cables. 3. Securing the cables at the new, correct length. 4. Ensuring all three lights hang perfectly level and aligned with one another. Requirements: - A licensed Electrician is preferred; however, a handyman highly experienced with light fitting installations will be considered. - You must have your own tools, including an A-frame ladder appropriate for a high commercial ceiling. - You must be able to perform the adjustments with precision to achieve a perfectly level result. - Public liability insurance is required. Location & Timing: Location: Westfield Penrith 582-586 High Street, PENRITH NSW 2750 When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Thank you.

I need to install downlight in the house and switch boards need to be updated accordingly. There are 4 bedrooms, 1 living area and 1 media room. In total 36 downlight, 7 dimmers, some safety switch upgrades.

Looking for a qualified electrician to install a 3 in 1 to our main bathroom, have the 3 in 1 & switch for this job, yes it’s a 4 in 1 but only want to utilise 3 of the 4.

looking for a licensed electrician to supply and install two (2) new power points. • 1 × double power point installed inside an IKEA BESTÅ wall cabinet • 1 × power point installed on backsplash in kitchen • Existing power point nearby for both areas (approx 1m - 1.5 m away) that may be used as the source Details: • Walls are gyprock behind cabinet • Kitchen backsplash is tiled • Neat, professional finish required • Must comply with Australian Standards • Compliance / Electrical Safety Certificate Requirements: • NSW licensed electrician • Public liability insurance Location: Penrith, NSW Timing: Flexible – ideally within the next week Please include in your offer: • Confirmation that you are licensed and insured • Including supply • Availability Thanks!