50 Light Installers in QLD

I need a timber beam light pendant (hollowed out) installed. The lights have already been installed and will wrap around the beam.

Hi, I need a ceiling fan/light installed to replace the existing light fitting. See pic. I will supply the ceiling fan/light.

I have a sub and amp as well as spotlights, light bar and front and rear dash cameras to be installed into my car. I have the wiring harness and dash switch for the spotlights and light bar. I am also looking at getting an anderson plug installed

I have got a ring floodlight camera and wanted to get it installed in front of the garage. But there weren’t any existing floodlight in place.

Need 2x9" spot lights attached & installed on a 2012 glx triton nuge bar have kings plug play harness would like have a xtm rocker switch installed if possible, aldo have a 22" light bar with a separate harness that I would like install near the grill

Fit new downlight and switch. Also add second double pole switch to existing room lights (e27 can lights) so lights can be turned on/off from both sides of room.

Ceiling fan installation for 3 bedrooms. One bedroom has old ceiling fan to replace, another 2 rooms replace the ceiling lights to ceiling fan with lights. I have the ceiling fans already, just installtion only.

Need to install fog light in both side of 2010 Toyota Corolla Hatchback. I have lights already with me. Just need quick assembly and installation. Thanks

Check on my skylight to waterproof and fixed.

Hi there just need a someone to install a standard 1 IKEA pendant lighting that we bought. Thanks

Want security sensor light installed back of salon

I should be able to control the Fan and light on the fan separately.

Lightweight 20 LED Security light and PIR sensor installed by licenced electrical. Hope Island.4212

One outdoor coach light to be installed low set brick home new install not replacement of existing light. Manly west preferably today please. Light is supplied

Kindly read the description prior for clarify sake. 1. There is a new Fan needs to be intsalled in kitchen area. It works with remote. Hence, there is no practical need to install separate wall switch. However, if specifications says one must even for remote operated fan then please consider that as part of job. Presently there is no separate fan switch. ( Attaching pictures of fan , Roof access, lights switch board and install area ) 2. There is a new flood light needs to be installed. It will require wall mounting flood light and also running electric line to power the flood light. ( Attaching pictures of flood light, area where flood light needs to be mounted and expected area to run cables. Note : Please provide electrical work certificate of compliance after job completion. Thank you.

I need 2 x laya small pendant shade lights installed to replace existing (broken) pendant lights.

1 light to be installed in the dining area of house

I’m looking for an electrician to install 13 down lights in my apartment. I have the down lights ready to install just needing someone to connect them up. Down-lights I bought are slightly bigger than existing hole. Will need to make hole to size

One lounge has an existing down light that we would like a fan put in, the other lounge has no hole but we’d like to pop a ceiling fan in the centre of the room. Also, above our dining table, a pendant light installed where there is currently a down light 👍🏼

Looking for someone to connect up 4 work tray lights to and 1 led front light. Lights already installed only need Electical connections done on an Amarok v6. I have harness for front light that just clips into high beams and need the other work light connected up from tray. Happy to do on hourly rate plus material costs. Should only take a hour or two. Please only apply if you have done something like this before. Thanks