Find trusted local electricians in Kew VIC

Take down this entire light fitting, which was broken, and replace it with the same kind of light fitting, which is in the photo. It is a Patino pendant light 300mm

I need an electrician to install a power point on my bedroom wall (ideally recessed) and hang a “43 Samsung tv on the wall. The power fuse box is on the other side of the wall.

New external 3 pin single phase outlet, up nearer to awning motor. wiring to be internal behind brick work ( no external conduit) there is currently a plug at lower point on bricks as shown on photos

Looking for electrician to check and fix kitchen light connection. Lights are dimmable, but sometimes doesn’t turn on/off properly, sometimes will suddenly flash a couple times and then turn off itself.

Need assembly of elepticsl cross trainer upstairs

Qualified Fire Services Electrical Contractor Required – Melbourne We are seeking a suitably qualified and experienced fire services electrical contractor to undertake regular inspection, testing and preventive maintenance of fire and life-safety systems within a mixed-use residential and commercial building with a basement carpark. The scope may include: * Smoke detectors and smoke alarm systems * Fire detection and alarm panels * Emergency Warning and Intercommunication System (EWIS) * Emergency lighting and illuminated exit signs * Associated batteries, controls, interfaces and fault monitoring * Identification and reporting of defects * Maintenance records and service certification for the Annual Essential Safety Measures Report The contractor must hold relevant Victorian electrical licences and fire-services qualifications, have appropriate insurance, and be experienced with mixed-use buildings, ESM requirements and applicable Australian Standards.

I need down-lights, GPO and aircon done for a skin clinic. Only licensed electrician as need certificate when complete.

I've got approximately four days of electrical work involving replacement of switches, GPOs and downlights, plus new LED strips, exhaust fans, feature lights and towel heaters. I will be supplying the fittings. I'd like to agree a fixed labour price for the complete installation. I'm allowing up to four 8-hour days, with any additional work agreed before proceeding. The electrician would be appropriately licensed and delivery would include testing and certification.

Looking for a licensed electrician to supply and install concealed LED strip lighting in the following areas: 1. Under the overhead kitchen cabinets to illuminate the benchtop. 2. Inside the three new shelves on both sides of the fireplace. I would like a neat, high-end finish using recessed aluminium channels with diffusers, so the LED strips and wiring are concealed. The shelving may need to be cut or routed to create the lighting channels. Please recommend the most suitable lighting system and colour temperature. Warm white lighting is preferred, approximately 3000K. The task must include: - Suitable LED strips, aluminium channels, diffusers, drivers and other materials - Cutting/routing the required lighting channels - Concealed wiring where reasonably possible - Connection to suitable switches or existing power - Complete installation, testing and clean-up - Electrical work completed by a licensed Victorian electrician Please advise whether you can complete both the electrical work and the required cabinet/shelf routing. Photos show the current kitchen and fireplace shelving. Budget is $500. Please specify clearly in your offer what materials and work are included.

Replace 15 high-ceiling downlights – Kew Need 15 existing downlights replaced in a high-ceiling area of my house. I already have all 15 replacement downlights. Ceiling is approximately 5–6 metres high in some areas – photos attached. You must bring your own suitable high-access ladder/platform/equipment and be experienced working safely at this height. Looking to have all 15 replaced in one visit. Location: Kew Budget: $300

I am looking for a qualified electrician to help install two smart toilets in two separate bathrooms at my home. Both bathrooms will potentially require a new power point installed. I need to ensure that all electrical work and the final placement comply fully with local government regulations and safety standards. Toilet 1 - B&H Back-to-Wall toilet suite with a TOTO WASHLET requires a waterproof electrical supply. Will need a new powerpoint installed for this toilet located within reach of the WASHLET’s power cord, typically positioned safely outside the splash zone or discreetly routed according to Australian electrical standards Toilet 2 - Caroma Urbane II CleanFlush BTW Toilet Suite (Back Entry). Not sure if powerpoint in bathroom would be suitable. General Help in setting up. Plumber will also be in attendance. Photos below of 2 bathrooms.

Our gas hot water system has broken down. We'd like to replace it with an electric heat pump. We'd like an Aquatech X8 and for someone to come to our property to remove the old system and install the new one (including the electrical work).

I’m looking for a licensed electrician to inspect and repair two ceiling lights. * Light 1 (Stairwell): Located above the stairwell at approximately 5 metres high. The light flickers continuously. The bulb has already been replaced, so it may be a wiring, LED driver or fitting issue. * Light 2 (Bedroom): The ceiling light does not turn on at all. The stairwell light is approximately 5 metres high, so you’ll need a suitable extension ladder and your own tools. Please only apply if you are a licensed electrician.

Need a licensed electrician and licensed plumber to visit first and then install all electrical and plumbing connections, equipment in a new beverage site in Kew, VIC. Work includes: * Connecting and installing bottling machines and SS tanks * Installing water pipework/ drainage * Connecting pumps, filters, UV, and ozone systems * 3-phase electrical connections * Testing and commissioning Please provide your licences, experience, quote, and availability.

I need a certificate of electrical safety for my small unit one room one living one bathroom. Super small. Unit hasn’t had power for about a year or so. Just need this to connect the power again. Thanks 😇

I need a licensed electrian to help wire a hanged ceiling light. I've hanged the light, but just need to wire it to a new cord through the ceiling. The light is upstairs and there is roof access. the closest switch board has one switch and an adjustable wheel.

ABBOTSFORD: Power point on wall (20A) not compatible with plug on electric smoker unit (32A). Power supply is adequate, just incorrect power point. Smoker runs on 17A. Runs on a 25A breaker. Location incorrectly listed by Airtasker as Kew--this task is in Abbotsford, VIC.

Install a ceiling fan with light in bedroom of apartment. Needs electrical expertise. Ceiling fan is remote operated but existing light needs removal and wiring for ceiling fan/light replaced.

New powerpoints in living room, kitchen 4 in total

Looking for a licensed electrician to complete the following: Remove 2 wall sconces Replace 4 pendant lights with new pendants (photos attached) Swap positions of 2 existing pendants and replace 1 ceiling light Adjust height/alignment of 1 pendant light Existing wiring already in place. Light fittings supplied. Requirements: Licensed electrician only Clean and careful workmanship Must provide Certificate of Electrical Safety if required