Find trusted local electricians in Gold Coast

Two power points either side of light in garage roof

Air conditioner has stopped blowing cold air. Need it repaired

32 amp breaker and power point, single phase, needed for an ev charger. Charger has a built in RCD. Panel has space for a breaker. Install onto concrete wall near panel

I need an experienced electrician to step in for 2 days to complete a Reno job. Task includes: Exhaust fan cut out gyprock, and fit off gpo and Ethernet plates. Would love if you could help this weekend (29/30th) but open to work with you. Needs to be this week.

.My air conditioner is 15 years old but brand spanking new and has never been used, but it’s leaked since installation. The installer has since gone out of business, and the BSA couldn’t assist. The BSA guy was useless and said maybe a bug grew a nest and just closed the case 🤣 A technician previously suggested it might be a design flaw with the U-bend connection under the sink, where the condensate line drains. The leak seems to occur inside the wall near the indoor unit, usually after running for about 20 minutes. If I use a wet vac on the drain line, the leak appears to stop temporarily — so it may be a drainage or backflow issue. I may also be dreaming about the wet vac but I thought it worked but maybe it was turning it off that worked and on again? I’m looking for someone experienced in split system AC drainage issues who can: • Diagnose the cause of the leak (possible drain line or installation fault) • Repair or reroute the condensate line if needed • Ensure the unit drains properly without leaking into the wall FYI MY BUDGET IS FOR TINKERING AND FIXING UNFORTUNATELY I DO NOT HAVE A BUDGET FOR A MORE AMBITIOUS SOLUTION… Please bring any tools needed for testing, vacuuming or blowing, or reconfiguring the drain line.

Certified Electrician to replace induction cooktop

Supply or we can buy warm LED strip to add to backing of 3 large mirrors 210×140 before builder hangs them onto wall.

Install a new air conditioning unit and remove existing unit. It is a back to back set up, with all power and ducting in place

Hi, I’m renovating my laundry (pre-90s house) and found an old red/black/green electrical cable cut off inside the wall, located about 1m below two working power points. The wall is open and easily accessible. I need a licensed electrician to: test the cable to confirm if it’s still live/connected safely disconnect it at the source or properly terminate it in a junction box with connectors/blank plate ensure everything complies with current electrical standards It’s next to a copper pipe, so needs to be made safe. Jobs in highland park 4211 Please bring required materials and provide licence/insurance details. Flexible with time — sooner the better.

I have 13 internal ceiling lights that need replacing as well as a sticky wall switch. I already have purchased the lights. Flexible on date but prefer a Friday or Saturday

Replace 2 downlights one in kitchen and an ensuite

Electrician to install 2 pendant lights over kitchen bench wiring already in ceiling just need to pull through and install

Add a generator breaker and plug to power box

I have a house with Hardline cat 6 running to multiple rooms in the house but a few aren't working. I need them tested and repaired

I need 3 switches in my house repalaced- 2 light and 1 power

I need a new powerpoint switch - so it can be 4 points and also works the oven, also the fan fixed so the cord stops falling out - licensed electrician needed

Hi everyone I’m looking to replace the motor and bars on my AC. The swing thing isn’t working Also to do service one completed

I’m replacing my existing hard-wired oven (20A) with a new oven that has a 10A plug. The current setup is a hard-wired 20A oven circuit (with existing cabling in place). I need a licensed electrician to: Disconnect the existing hard-wired oven connection. Install a standard 10A single power point (or double) (surface-mounted or flush, depending on what suits). Replace the 20A circuit breaker at the electrical switchboard with a 10A breaker to suit the new outlet. Test the circuit for safety and compliance (RCD, earthing, etc.) Notes: The existing cabling and circuit are already in place — just need conversion to a socket outlet. The new oven is 10A with a standard plug (comes fitted). Please bring all required parts (10A socket, 10A breaker, etc.) and include them in your quote. Location: Robina When: Flexible — ideally within the next week. Requirements: Must be a licensed electrician (please include licence number in your offer).

Need to swap out an overhead hanging light for another that is the same size. Ideally any morning before 20/10. Thank you!

Electrician to install an electric cooktop, move one gpo through 1 stud and fix kitchen gpos correctly. Sorry no photos.