Find trusted local electricians in Gold Coast

Looking for an electrician to swap over a light fitting to a new one.

Need handyman to replace 4 high ceiling globes. Cant reach on my own. See pics for height. I have the bulbs. There are 4 only.

(1) Shop front LED Lit signage with transformers ready for an electrician to install urgently. 🪜 is needed for 3M high, 3.5M wide. (2) Reception area signage (no LED) ready for a handyman to install urgently. (3) 3 LED down light replacement by electrician (4) additional PowerPoint X 1 by electrician Location 📍 Biggera Waters Any sign-specialised electrician and handyman only. Thank you. 🙏🏻

Replace 2x electrical points as in photos and one light switch.

Site Inspection: ASAP Expected Start: Approximately 9–14 September 2026 Preferred Site Start Time: From 7:00 AM Licensed electrician required for an active bathroom and ensuite renovation. The demolition/open-up stage has identified some unexpected concrete walls, so we need the electrician to review the current layout and confirm electrical requirements before final rough-in. Scope may include: • Review existing electrical installation. • Confirm lighting locations. • Confirm power-point locations and requirements. • Review exhaust fan requirements. • Isolate, relocate or make safe existing electrical services where required. • Complete electrical rough-in to suit the final bathroom and ensuite layouts. • Coordinate with the carpenter, plumber and plasterer. • Return for final electrical fit-off. • Test and certify completed electrical works. • Provide progress and completion photos. Please provide: • Current electrical licence. • Current insurance. • Availability for an ASAP site inspection. • Availability for rough-in between approximately 9–14 September. • Hourly rate or fixed-price structure. • Relevant bathroom renovation experience. Good communication, reliability and the ability to work within a coordinated renovation program are essential.

I need a licenced electrician for install 2 outdoor power points for plugs. Looking for someone to come out and evaluate the installation. Im guessing running power off the house with a cable underneath the garden to the retaining wall.

Need aircon pipes recovered with the insulation foam for around the copper pipes and the white pipe. I have purchased the product just need it repaired today.

Rinnai HFE250SSL 250L hot watee sys not working, suspect heating element or thermostat failure. need it fixed asap.

Looking for a licensed electrician to complete a few GPO installations/relocations in my home renovation in Highland Park. Wall is currently open, so access is easy. Please see attached photo for locations. Install/relocate 4 x double GPOs One includes a middle switch for LED lighting Remove existing GPO marked with ❌ I already have all the switches/GPOs Thank you 😊

Air conditioning unit stopped working, switches on but no function after that. Old style unit looking to fix for a house sale rather than replace. Need job done asap. Thanks

I have purchased a piece of equipment from China and need the wiring concerted to Aussie standards and safety check

Job Overview I need the colour-temperature selector switch adjusted on approximately 43 existing LED downlights in a two-storey home. IMPORTANT: The ground-floor ceilings are approximately 3 metres high — considerably higher than a standard residential ceiling. You will need to bring suitable ladder/access equipment for this height. The lights are already installed and fully operational. No replacement fittings or new lights are required. Scope of Work Approximately 25 downlights downstairs 18 downlights upstairs in total, including the 2 located over the staircase Change each downlight from cool white to warm white using the existing selector switch on the fitting Carefully lower each fitting enough to access the switch Change the setting and reinstall the fitting securely and flush with the ceiling Take care not to damage ceilings, paintwork, retaining clips, wiring or fittings Ceiling Height & Stair Access Ground-floor ceiling height is approximately 3 metres, NOT a standard 2.4–2.7m residential ceiling. There are also 2 downlights positioned over the staircase, which will require appropriate equipment and safe access. Please only offer if you have the appropriate ladder/access equipment for the 3m ceilings and the two staircase lights. Please quote for completing the entire job and confirm your availability.

Movex3 light switched 2 inches. Installed 2 power points directly opposite existing power points next room. Replace 6 lights with recess lights. Wire up new 2 extraction fans. Install front outside light. Replace existing back exterior light. Replace 2 fluoro lights with recess lighting.

I need someone with a demo saw / concrete saw to cut a notch into a concrete floor at Palm Beach. - Length: approx 2 metres, straight line - Width: approx 50mm - Depth: approx 30mm (deep enough to seat electrical conduit - happy to take your advice on site) - Purpose: laying electrical conduit into the slab Please bring your own saw, blades, water or dust extraction. Wet cutting or dust-controlled cutting preferred, as this is inside a finished space.

4 x Fans to be replaced 4 x Ceiling Lights to be replaced 4 x Wall light switches to be replaced 1 x electric over install Low set house easy access

Looking for a licensed electrician to inspect and repair/replace 2 x downstairs recessed ceiling lights: * 1 x toilet light – stopped working. * 1 x laundry light – was working but stopped after replacing globes. * Both are older twin E27 recessed fittings. * Existing CFL globes show signs of heat deterioration. * Inspect/test circuit, wiring, connections and fittings to identify cause. * Replace both fittings with suitable modern LED fittings if recommended. * Test and confirm safe operation on completion.

I need someone to inspect and repair the electrical wiring on my 4x6 box trailer. The trailer plug is damaged and the lead/wiring may need to be replaced. I do not have a replacement lead or plug, so the successful tasker will need to supply any required parts. The job includes: * Inspecting the trailer wiring and lights * Replacing the damaged plug and lead if required * Repairing any damaged wiring * Testing all indicators, brake lights and tail lights to ensure everything works correctly Please include labour and parts in your offer, or clearly state any additional parts costs.

Looking for a licensed electrician to replace a broken ceiling light fitting in my home. The existing fitting appears to be damaged/broken (see photos). I need the old fitting removed, a new standard batten holder or similar installed, and the light tested to ensure it’s safe and working.

We have quite a few light globes out + 2-3 down lights. Just needed new globes put in and wipe over the tracks please. We can supply globes after seeing which ones we need as I don’t think we have enough