Find experienced deck builders in Sydney

Looking for quotes for replacing our rooftop decking. I had posted previously but unfortunately the post expired, so can’t access the offers/msg’s, please get in touch again if you are interested and have availability. Remove current timber decking and install composite decking - Ecodeck Designer series. Please note this is for the sides as well as the floor, we want to replace the whole rooftop not only just floor. Please include material in the quote or advise if only quoting for labor. Decking size: 3.2m x 4.7m Location: Surry Hills, Sydney NSW 2010 Will need to bring and have your own tools. Please get in touch if interested and need any more info. Would be great if could share pics of previous decking jobs.

Composite Decking boards replaced; mostly the edges where there is visible degradation. Also one or two boards that are a bit warped. A quote and first availability is appreciated.

Lift 90x boards of Composite Decking onto site tomorrow morning - Due date: Needs to be done on Tuesday, 23 August 2022

Deck 2.5m x 5.9m x 0.25m Patio 2.5m x 5.9m x 3m House Full width 6.7m Ground to Sliding door height is 0.15m LED x 6 warm white Fan Post lamp Composite deck Location: Rousehill

Licensed carpenter to replace existing decking boards with new Timbertech composite panels (provided). Decking panels are 140mm wide. Existing framing is in place but some minor adjustment might be required if additional support is required below. Provide and replace an existing fascia board, with a new solid timber panel and replace two of the balusters which are rotted with new ones. Deck dimensions Porch section 1.3m depth x 4.6m width Main section 3.4 depth x 3.6m width

Clean, sand, oil rear deck/ seats/ posts/ steps (c. 30sqm), front deck 18sqm and feature wall (5m X 2.5m) internal stairs/ landing. Timber oil, cleaning product and brushes to be supplied. Two coats of oil and deck cleaning product to be applied (prior to oiling). I can provide Sanding machines and paper. Method per link below: https://www.bunnings.com.au/diy-advice/building-construction/decking/how-to-oil-your-deck - Due date: Before Saturday, 15 July 2023

Sand a small timber deck area - 4 x 5m Supply own sander

Timber deck, needs painting. Previously stained. 8m x 4m, paint will be supplied only-painting equipment you will need to have

Construction of a 5m x 5m deck off existing steps

Clean timber decking using Timber Prep solution, then return 24 hours later to apply decking oil. There's approx. 230sqm of decking in total, likely to be a 2-3 day job. Cleaning solution, oil and equipment supplied.

Build a timber handrail to existing timber deck. Spotted Gum. Sand & Oil to seal, both handrail & deck. 2 x 4 m’s.

Sand back weathered timber deck and re-oil. Deck is 3.2m x 4.8m, with a small step down to grass. Have the oil for the deck - see photo.

Replace outdoor timber decking. Deck frame ok. Timber decking needs to be replaced as they are weathered and old. 3.2m x 4.83m. Current timber slats 90mm wide. Circa 140 linear metres (taking into account the curved shape of the deck) Small step also needs new timber. Open to timber suggestions. Uncovered deck that gets about 6hrs sunlight a day. Budget depends on timber? Open to negotiation.

Our neighbour and us would both like to get our front and back timber decks sanded and re-sealed with clear oil. We can purchase the oil.

Replace/repair timber decking (small area) This small section (3620x555mm) of old outdoor timber decking is sagging downwards because the crossbeam below is rotting. I'm looking for someone to fix it up so that the deck no longer sags. I think the crossbeam needs replacing but the pieces of the deck itself don't need to be.

Clean and treat (decking stain/oils) small timber balcony in a terrace. Please provide itemised quote.

One of the crossbeams under my deck has rotted away, so a couple of the top slats are bouncy when you walk on them. It is sitting directly on a concrete slab, so there's no safety issue or anything. I reckon to fix it, it'll require pulling up the slats, replacing the crossbeam underneath, doing some fiddling to get the height right, and then nailing the slats back down. I would prefer if you can supply the materials, but if you need, I could get a new wooden beam. In the photo you can see where the top slats are dipping down because the crossbeam isn't holding them up from underneath.

Replace 4 large + 2 small spotted gum timbers on my decking and post on fence which my dog chewed when he was a puppy

I have a very small piece of my rear courtyard timber decking (approx 60cm x 10cm in size) which has rotted through and needs replacing. Available times: (1) Sunday 21 Jan (after 3pm) (2) Wednesday 24 Jan (after 3pm) - Due date: Before Wednesday, 24 January 2024

Need someone to clean & oil timber decking. Will involve moving some furniture off it first (dining table & chairs storage cabinet) - Due date: Before Friday, 22 December 2023

Replace timber decking with new composite timber or equivalent. Approx 3x1.5 deck with additional finishing around raised garden bed. Steps will remain as is. - Due date: Flexible

Approx. 16 sq metres, ordinary dirt and grime. Need to move some pot plants and outdoor furniture. Engineered timber-like decking made from recycled materials--approximately 8 years old, otherwise in good condition. Easy access to tap and outdoor powerpoint. - Due date: Flexible

I am preparing my house for summer and need the deck on the verandah re-stained. I work from home on Tuesdays and Thursdays and prefer this task be completed on either one of those dates. The deck is approx. 400m length x 125m wide - Due date: Before Saturday, 18 November 2023

Build Timber Deck - 4m x 5m On top of current pavers Can supply materials - Due date: Before Friday, 20 October 2023

We have a small Blackbutt timber courtyard deck that needs to be replaced, it’s 3.5m x 3.5m (13sqm) and nailed to a treated pine frame. When first installed we had the area ground levelled compacted, plastic sheets were placed over the ground and a treated pine frame was built before the Bluckbutt timber was nailed on top. The first job was very well finished by a friend. In the last photo you can see there is a small section where a hatch can be lifted to access a sump drain below. We would like both the Bluckbutt timber and the treated pine frame to be replaced. We are replacing exactly as it currently is (Same dimensions, Same timber). We are interested in quotes for installation only.