Find experienced local carpenters in Newcastle

I have installed a dishwasher in our kitchen which required shortening one of the modules to fit. This was a corner module with a hinged double corner door which needs to have one panel of the door cut and rejoined to fit the narrower section. This will need to be taken out of the centre due to the decorative boarder and also the hinge insets. Can deliver the panel almost anywhere Newcastle/Hunter as I travel daily for work.

General carpentry for all aspects of building. Renovations and maintenance related repairs.

I need a solid aluminium rod cut down to the same length as a wooden dowel pin from my child’s bunk bed. The rod is 10 mm thick, and I’ll provide the wooden pin as a size reference. Task is simply to cut the aluminium rod cleanly to size — tools required (saw/angle grinder/etc). Should hopefully be a quick job for someone with the right cutting tools.

Sand back and stain deck Approx 10m x 2.5m

I would like two floating shelves in my living room replaced with thicker timber and more steady. I would also like a floating shelf added too my sons bedroom approx 2m long

I accidentally placed a hot pot on my wooden kitchen bench top a while ago, which caused a burn/heat mark. The spot turned black at first and later became a white cloudy mark, as shown in the photo. I’d like someone experienced with timber furniture or bench top restoration to repair or refinish the affected area. Please let me know your approach and quote. Photo attached.

Cut and install V groove MdF panel

To be on site at 8am. Supply and install 57mm backset tubular latch. Sand and bog faulty ply board. Remove and dispose of extra building materials.

Timber deck, facade and stairs approx 8m2, and timber landing pad approx 1m2 to be. sanded and cleaned. $150 ono You will need to supply your own sander as mine is broken.

Looking for cabinet makers To build a alter ( picture)

Small outdoor deck and side stairs require staining.

New house needs wardrobe including WIR to fix out. You need to advise us materials or bring which we will pay. Money in offer is labour costs including any small utensils not the materials. Materials give us invoices we will pay

I need a deck stripped and restained. It is roughly 8.5m wide by 2.5m wide. I also need the front and stairs done too.

We need a platform step for the entrance to a foodbank. We have all the wood and brackets. There is a slight slope so it needs measuring and fitting to be level.

like to remove just water stains instead painting whole ceiling. 2 places, one of them can see uneven spots as well

Need someone to install some yellow tongue flooring in attic (5 or 6 boards)and trim around attic ladder

We need a timber dining table and bench seat sanded and refinished. Both are made from Tassie oak.

I have a burn mark in our kitchen bench top. Please provide me with a proper quote and time available for you to finish the job. Thanks heaps

I need the slabs of timber below cut horizontally either in two or three pieces

Plywood ceiling panel install