Find experienced local carpenters in Wallsend

Cutting existing side slats and creating a frame behind it then hinges and handle to make it into a door for storage under the house. Just like the one I already have, I just want another one next to it for easier access under the house. I have handle, you are to supply wood frame and hinges

Cutting existing side slats and creating a frame behind it then hinges and handle to make it into a door for storage under the house. Just like the one I already have but a smaller version.

Remove and replace 3 sections off outside wooden railing. All material will be supplied buy me.

See the photos for better idea. Need to fix 3 panels 2 sides. One ceiling Panels supplies. (Check the photo)

I have just noticed that the brick under the front of the house has bowed a fair bit, and someone has had a go in the past at a bodge job (I notice another bit of timber fixed across the front bearer) Until it can be rectified fully, I would like someone to install an adjustable Uni-Pier, with a simple small concrete footing (access is difficult). This is just an additional subfloor pier in case the brickwork gives in. Note: Since the front bearer may have some old water damage, it might be better to place an adjustable pier on the perpendicular bearer (at the intersection of the nearest joist) - See photo.

See on the photos. Unfinished work. Need to fix the timber false wall or any better suggestion

I have some stud walls that I needed to be made higher by approx a meter. Needing some quotes.

3 bedroom home cypris pine floor to be sanded and refinished. Either 70m2 or 35m2 depending on cost. I might carpet the bedrooms. Thank you.

I have attached the likely design, but may add more wall cabinets. The wall is 3m wide. Looking for a high profile cabinet maker. Second photo shows the style I am after: country style for doors Location: Wallsend

Install insulation (anticon 60 product) under the existing metal roof sheet to a small 7m x 5m timber shed (roughly 35m2). - Take off existing sheets and ridge - Install anticon to manufacturer instructions (2 rolls of 15m required) Bradford Anticon 60mm Roofing Blanket Light Duty Foil R1.3 15m x 1200mm (or 1500mm) - Reinstall sheets over the top - Reinstall capping/ridge - Check waterproofing and apply silicon where required * Note there are no existing leaks or water ingress.

Cut down 3 kitchen cabinets with laminate saw and attach cabinets to wall.

Basic carpentry work needed potentially 6 hours, built 5 townhouses just need some basic work done to fix staircases.

You will cut to size and fit backing board (masonite or similar) to rear of three very old kitchen cabinets. Possibly also on top of one or two of the shelves which are a bit warped. I will be painting the cupboards afterwards. I will pay for materials, but you'll need to provide them. Bunnings is nearby.

I would like a a quote for built in cabinets and quote for built in cabinets with bookcase similar to those as in picture. Must be able to provide photos of previous work.

Cut an nail timber trim round two windows 90mm x 18mm, Approximately 15LM trim, Timber supplied,can b there to lend a hand.

The existing staircase to be removed, Then, new landings, new stairs, new handrails Open to get your quotes - Due date: Flexible