13 Carpenters in Seaford

I require a brick letter box pier to be built for two units. Dimensions are as follows- Height - 1.2M Width - 300MM Length - 500MM I require an experienced brick layer. I will supply letter box but all other material to be supplied by air tasker including brick, sand etc.

Wooden cubby house with slide, monkey bars and two swings. Covered verandah. Three windows made of Perspex. Two are openable. Structural grade timber. Colourbond roof. Internal dimensions: *Floor - 1550mm x 1550mm *Highest point - 2100mm External dimensions: *Overall height - 3500mm *Extreme width of cubby house - 1950mm *Extreme depth of cubby house - 2500mm *Slide - 1900mm *Monkey bars - 2800mm *Total extreme width = extreme width of cubby house 1950mm + monkey bars 2800mm = 4750mm *Total extreme depth = extreme depth of cubby house 2500mm + slide 1900mm = 4400mm Box hill dismantle Assemble Seaford

We need an external door frame installed and the weather sealing (including the strip at the bottom) done around the frame. Our house is a timber frame. I had a go at it a couple of months back with a for frame that was given to me but nothing was square. While our door currently locks it is neither pretty nor practical. The existing door is approximately 2000x800 and we would like to keep it, but would be open to replacing it too. There is a wheelchair user in the home so we need the entrance to be flat and unobstructed by the door frame and weather seal. We will need you to supply the entrance door frame and weather sealing stuff, and I have tried to reflect that cost in the budget. All quotes will be considered.

Following a small fire my deck sustained some damage. I am looking for a handyman to remove and replace the 8 pieces of damaged decking. - 1 vertical. - step - 6 front panels Note: none of decking boards are damaged. I can provide paint complete the painting of panels.

Hey there, my name is Ryan. I need to hire a handyperson to help me in Seaford VIC 3198, Australia. What do you need done? Carpentry, Please build me Vinyl LP Storage on site What is the type of property? House What would you like the handyperson to work on? Build LP storage in my study. I have photo examples available.

I require someone to install a flat pack shed on an existing concrete slab. Price is non negotiable and we need it done Wednesday

We require someone to assemble a garden shed - 3.6 X 2.6 x 2.3 Existent concrete slab ready to assemble on

I have an old sewing machine stand that I would like turned into a table, so basically just putting a bit of wood on top. It is also a bit rusted so needs a bit of TLC.

Build a brick garage attached to side of house 5.5m X 3m with a roller doors font and rear

Hey there after a chippy or cabinetmaker to install 2 overhead cupboards in laundry and also floor cabinet and bench top All cabinets and bench top supplied

Need a new garden shed put together. It will be 2 x 1.5 mtres. Job needed in about 2-3 weeks time. Garden area will be prepared. Quotes please.

We have 2 timber awning windows we would like fixed. The kitchen window does not close properly, it gets tight in its frame. The laundry window does not open. It is stuck in its frame and trying to wind it out causes the timber in the corner to try and separate.

Need our shed assembled on Wednesday on a concrete base. See photos. Price non negotiable and it must be Wednesday

Honda Civic approx 12 years old need large dents taken out

I have pulled down my old 3m by 3m garden shed and now need it to be removed from site. These are metal panels that are no larger than 2m by 2m. So it would pay to bring tools than can cut these down as required. I will leave the panels in the front of my house.

I need a wheelchair ramp built in my back yard. The top step at the back door is 300mm high and I have concrete in most of the yard, running for about 10 metres. By my estimations that is enough for a suitable ramp. Timber decking is my preferred material. Photos to come.

Needing a qualified carpenter to complete house renovations service is required asap house is at frame stage on the inside needing help to complete...

I have ordered kitchen cabinets from Amorini in Clayton to be ready Thursday 14th March. I have also assembled a new vanity for the bathroom I need Someone to Install kitchen cabinets and vanity

Hi We require someone to assemble a garden shed 2.6 x 3.6 x 2.3 Please see pic attached - will be placed on existing concrete slab Many thanks

Need to construct a coffee cart (basic)