Find an experienced driveway repair contractor near you

Need help to repaint the driveway as got some patches

Wheel barrow loads of wet concrete from concrete truck 5m and dump on driveway Approx 20 loads Less than an hour 9:30am

Gates suppled just need post and erect

Need a competent operator to drive a 1.8t excavator for a day digging out tree roots and driveway

Looking for Quotes – Aluminium Sliding Driveway Gate Our aluminium sliding driveway gate was destroyed in a recent storm and needs to be replaced. Looking for quotes for: Aluminium sliding gate Approx. 4 metres wide x 1.8 metres high Similar style to the existing gate (happy to discuss a few design improvements) Supply and installation Located in Boronia, VIC. If you're a local supplier or installer, please comment below or send me a message. Thanks

Looking for quotes to install shade sail in driveway

Need to Install Manual Sliding Door to the Driveway.

Need a solar security camera mounted to view my driveway. Just require the camera bracket securely bolted to an exterior wall. Quick, simple job.

Client has pulled out the bamboo in the picture. I need all of the bamboo that’s been pulled out to be removed. Would prefer it to be put in a trailer and taken to the tip. Do not worry about removing any more bamboo that’s still in the ground.

Looking for someone experienced. Need new drain stored. Must have experience with this.

Driveway is build couple of years back but I require Resealing of it with pebbles concrete finish. Additionally, I also need to complete the garage floor coating. Garage area is 5.5 x 5 meters and drive way is 5.5 x 9 meters.

Task: Remove Existing Side Gate & Supply and Install New Colourbond Gates Remove existing side gate then then supply and install a new black Colourbond gate system. Scope: • Remove existing gate/fence • Supply and install galvanised steel posts • Supply and Install two matching black gates, metal (colourbond or similar), either solid or vertical posts with minimal gaps • Side gate posts to be 75x75x2mm gal posts, 1.95m in height out of ground to match gate height. • Posts to be set in concrete in post hole, approx 70x80cm deep. • Gates to be hinged off posts. • One gate to have pad bolt to ground, the other gate to have a keyed handle to secure. • Gates to open inward (ie. Towards back of the block) • Approximate width of driveway: 3.5m (building to boundary fence) • Desired height: 1.95m • Ensure gates are level, secure and operate smoothly Easy access. Please include all materials, and labour costs in your quote (disposal of old gates not required). Photos attached.

The soil is a mix of good and clay with a few bricks, a few small roots. Good for landfill. You will need a excavator to remove it.

I'm getting 3 cubic metres of sandy loam dumped in my driveway. I need to move it and spread it over my sodden backyard lawn. I have a wheelbarrow and trolley and tools/spades. I need someone fitter than me to help me get it done. Would like it done this weekend so I get my driveway back.

We have the paint and rollers and tape, but we can't do it, the surface has been prepared and is ready to go, it needs two coats with a two-hour drying time in-between coats the driveway

I am looking for someone with experience in earthworks and access to suitable machinery to help prepare access to my home-based dog grooming salon. The property currently has a steep, muddy slope with no existing pathway. The job includes: Excavating and levelling a pathway from the driveway to the salon entrance Levelling and improving sections of the driveway Creating a safe and practical access route for customers and their dogs Cutting out and preparing the pathway area for weed mat and rock installation (weed mat and rocks will be supplied and installed separately) General site tidy-up of disturbed areas The property is located in Cockatoo, VIC. Please let me know: What machinery you will use I have included a photo of the pathway I am after. I will need the wood beams installed but not the gravel. Photos can be provided, and site inspections are welcome before quoting. Completion before 12 June highly preferred as access is required for a home-based business opening

Need these 2 driveway ramps drilled screwed into the ground. 4-6 screws each. So it stays put

Replace broken concrete edge on driveway. Remove broken concrete/waste, clean out, rebuild edge with new concrete, making smooth & level. Approx. length of damaged area: 1.8 meters

There are around 24 plants I need removing from a driveway garden bed, as they have become too large (wide). Video of job can be viewed at https://youtube.com/shorts/p0kseFOGADE?feature=share Time and date for works completely flexible. Price to include removal/disposal of plants - budget added as $10 as I have no idea the cost for a job like this - please quote. Thanks.

Just need some driveway lights installed please. 2x holes (on each light) which need to be screwed into driveway. Very easy job. Just don’t have the masonry drill bits. Total of 4 lights. Already have screws and lugs.