Find an experienced builder in Ashburton

We have a gravel driveway that needs some repairing. The driveway is shared and has some potholes and requires fixing. - Due date: Flexible - Due date: Flexible

I wish to have retaining walls built for my backyard using the interlocking concrete blocks. Dimensions of the area for the walls and photos are attached. Access to the backyard is through a 90cm wide gate. Must have full insurance and 2 recent references. - Due date: Before Sunday, 5 February 2023

Level down a sloped backyard of approx 6x3m and optionally build timber retaining wall (back and sides). Current vertical back height to pavers is approx 60cm - Due date: Flexible

Require someone with access to a small excavator to scrape some earth out to a depth of approx 5 cm in preparation for a new gravel driveway. Driveway is approx 12m long and 3.5m wide and will be pre marked out with stakes. Removed earth can be left on site. Estimate approx 2 hours work. - Due date: Flexible

Looking for a registered builder to do internal walls for a clinic in Ashburton. Total linear metres is 25 and height of walls is 2.9metres. Looking for a quote asap and reviews so we can appoint a builder. Draftsmen currently doing drawings for building permit however attached is the closest hand drawing draft. - Due date: Before Tuesday, 30 August 2022

I purchased a driveway gate which I need help to install. They will swing inwards and slightly upwards due to the slope of my land. I can provide photos.

Looking for a builder to build internal walls for a shop. - Due date: Flexible

Need to replace pergola polycarbonate roofing and seal the gap in between the roof and house. Currently rain comes through.. Please also discard old pergola sheets for us. We provide; Polycarbonate Sheets (need to be cut to fit), nails and silicone. Size ; Approx 7.5m x 1.2m Please give us your quote Based in Ashburton Many thanks!

Partial removal of outdoor pergola: Removal of 3 vertical posts (and concrete footings) and removal of overhead beams - Due date: Flexible

Auto gate doesn't close to the end.

3mX3m Absco shed new require installation on an existing flat concrete of 3mx3m size

Form , pour and finish approximately 0.4 m3 of concrete to 2 sections of driveway 1. 4 m x 0.8 m x 0.1 m - between trench drain and slight ramp up to existing slab of driveway (drain has been installed) 2. 0.4m x 0.5m x o.1 m - small section of driveway

Hi there, I’m looking for some assistance to set up a small outdoor shed. The area where I would like to install the shed is against my house, however the concrete ground is on a slope which means the shed will be on an angle. I would like some assistance to create a level surface to mount the shed. For this, I would like a level timber platform that is connected against the house so that the shed can be installed on top of it sturdily. I would then like some assistance to put the shed together. I have completed all of the surfaces, I just need a hand for the final assembly of it - as in putting the sides and roof all together.

Replace old pergola polycarbonate perforated roof sheets with new ones. I will pay for materials (sheets, screws etc), you will need to pick them up from local supplier. We can agree details later Roof dimension are 7M x 2.9M (9 sheets needed)

Demolition and removal of 15 m long 800 mm high brick fence. 80 year old clinker bricks which retail for $1.20 each.

A newly built pergola requires welding of 2 150x150 posts (total of 8x 150mm long welds). In addition 12 x 100mm welds of rafters). Please see photos for clarity.