Find experienced auto electricians in South Brisbane

Have a campervan and something is tripping the second battery fuse and I can’t charge from my alternator for more than 5 mins without fuses tripping. Happy to negotiate on price or per hour Hoping to leave on a camping trip this Thursday 🚐 It is still charging through solar and 240v. It’s a 300amp lithium kings battery. When I run my van, the fuses marked “main” and “auxiliary “ are tripping and stopping the charge coming from the alternator. When I turn the fuses back on it will work for a few mins then trip again.

Just wiring in a car amplifier

Description: I’ve got a set of aftermarket fender flares that need a full professional install on my car. This is not just a basic install — it will likely involve: - Drilling where required - Installing supplied clips (multiple types included) - Properly mounting and aligning the flares Main issue: The rubber edge trim/seal that goes around the flares is not fitting properly. It doesn’t clip on and falls off easily. It appears to be a “7”-shaped trim rather than a standard clip-on type, so it may require the correct method, adhesive, or replacement. Also, the flares are hollow, so only the outer edge contacts the car. I want this done cleanly with the correct approach so it sits flush and doesn’t look messy. What I need: - Someone experienced with body kits / fender flares - Confident with drilling and proper mounting - Able to sort out the rubber trim (fit properly or recommend better solution) - Clean, professional finish Important: - I want this done properly, not a quick temporary fix - You may need to supply or recommend proper adhesive/tape if required I can provide photos or show everything in person. Location: carindale/ carina area Flexible with timing

I am looking for a qualified Auto Electrician or experienced Dashcam Installer to fit a dual-channel dashcam system (VIOFO) into a 2026 BMW i4 (G26). The goal is a "factory-finish" look with minimal visible wires. Vehicle Details Model: 2026 BMW i4 (Gran Coupe/Liftback). Scope of Work Front Camera: Install using a Mirror Tap / Rain Sensor Y-Harness (hardware provided). Must be tucked neatly within the factory mirror shroud. Rear Camera: Mount to the rear glass. Critical Requirement: The cable must be routed through the existing rubber wiring bellows (boot) between the chassis and the tailgate to ensure it is invisible and protected when the hatch opens. Airbag Safety: All cabling must be routed behind the A-pillar and roof-line side curtain airbags to ensure full safety compliance.

I have the car play unit installed half way but was unable to change the entire reverse camera unit and looking for someone to help me finish the rest and dash camera installation

Needing someone to replace headlights on a Mazda 3. Parts supplied. 2010 model

Installing Fox battery and inverty. Add or upgrade any necessary switches. I'll need to buy the battery and the inverty.

Mazda CX5 -GT with Bose system. I’ve purchased a Sony XAV AX4000 have the patchlead, pac RP4-MZ11 just waiting on the fascia kit and dash cam. This is my second time posting as I’ve added the dash cam. I’m unsure if my speakers are broken but if they are I’ve purchased a second set to install. Need a hand installing the kit, and the new speakers if necessary. I’d like to speak to the installer to check if I have the right gear before.

Replace original stereo & horrible old speakers, Install double din head unit and new speakers (3-way & 2-way coaxials) only on a 2007 Honda Jazz.

Need Dual dash cam installed. I already have the dashcam and wire that needs to be installed. Prefer evening or weekend or alternate Friday. Please quote how much you would charge if you install this in Algester or Central. But if you are nearby then I can come to you as well if that's cheaper. Kia sportage. Front and back camera.

I need an auto electrician to fix the new starter motor in my 2000 Isuzu 1.5 tonne truck. Today if possible.

Need to install dashcam 3 channel in toyota camry 2021

There is a 50kwh Bluetti battery system that needs to be installed in a house

Reverse camera & display installation on Mazda 2 Link to product : https://www.amazon.com.au/dp/B0CP7MZJLP?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

baby car seat install tomorrow - secure installation

Hey there, I have a 2003 Mercedes Sprinter and I’m currently experiencing some issues with the van’s electrical system. To keep it brief: fuse #7 (under the steering wheel), which is connected to the air circulation system and the horn, kept blowing. I replaced it, but it continued to blow. At one point, I temporarily installed a higher amp fuse so I could start the van as I was stuck in the middle of the desert. The van did start, but the higher amp fuse eventually burned out as well. Once I got home, I identified the issue: a cable near the horn was exposed and touching the bare metal of the van, causing the fuse to blow. I temporarily fixed it with tape, and replaced the fuse with the correct rating. The van now starts fine, and no fuses are blowing anymore. However, I’m now experiencing the following issues: Some lights are dim (likely need replacing) The horn is not working The radio is not working I’m looking for someone who can properly troubleshoot the root cause and help repair/rework the wiring. Here’s what I’d like help with: Properly insulating and redoing the exposed cables (I currently have a temporary tape fix on 3 wires) Repairing the battery cable terminal (the screw for the negative terminal has broken) Diagnosing and fixing the underlying electrical issue Replacing any faulty lights I need this to pass a Roadworthy Certificate (RWC), as the van is currently registered interstate. I have some basic electrical knowledge and am happy to assist if needed. I can also remove the dashboard beforehand to speed things up and allow you to start troubleshooting right away. I’ve attached some photos for reference. I’m quite flexible with timing, and I’d appreciate a fixed quote if possible, as I’m currently on a budget. Of course, I’ll cover the cost of any replacement parts (like lights) separately. I also use Airtasker, so feel free to reach out there or here if you have any questions. Thanks in advance! Michael

I need a round 7 pin plug with a trailer brake replaced with a 12 pin flat plug fitted with an Anderson plug. I have a couple of other things also. Located at Coorparoo or Park Ridge. Price is negotiable.

Installation of hybrid in a bedroom

2015 Nissan Xtrail ST-L sedan. 2 x HBeam 2 x LBeam 2 x Driving / Fog Lights replacements to LED Status.

I have a tesla screen that need to install in my GTR r35. It requires the reverse camera run from the rear and then its plug and play. I want someone with experience with audio so it can be done neatly behind the dash. There are plenty of videos of how to install them. Install is in Carina heights