Find experienced auto electricians in South Brisbane

3 bikes, fj1200 yamaha, yamaha ag 175 , gpz900r. .the job is to change a plug connection on the fj, Finish applying the wiring loom, a new one oem with diagram. And test inspect stator on the ag 175.

Supply and install to a 2024 Kia Sportage Front and rear dashcam - hardwired Exchange key drive to keyless drive/entry

My sons Colorado is stopping randomly- our mechanic said it’s a wire issue

New replacement headlights purchased for 2007 VW Golf GTI - need to remove bumper, remove old headlights and install new ones. Lights and bulbs will be set up completely. Should be a straight swap.

Fit factory nudge bar to nissian navara d40

Replace alternator in Hyundai i30 2009 model. Would need to provide alternator and labour. Rego: 859RZA

Reverse osmosis system installation under sink. Take only 1 hour to install if done by a professional.

Replace alternator in 2013 amarok. Have the new alternator here ready to install.

Price on installation of Andoid carplay already purchased

I have got side steps , brackets and bolts .. needs someone to install it for me

Hi, i need my Ignition Switch replaced. I do not have the part so it will need to be supplied

My car is a Toyota Yaris 2006 1.5L and the tail lights arent working i replaced the bulbs and its not working still the fuse i replaced and still not working the license plate number lights also dont work. Also if you have an engine light reader for another car i have bring that too.

I bought a new reverse osmosis water filter system and I need it installed.

Hi i have a second hand alternator that needs to be installed and the old one taken out. 2006 1.5L toyota yaris. Little information on the alternator. I want it sold before Friday its urgent so only get in touch if you can complete it today or tommorow.

2013 VW Passat Alltrack 2.0TDI having an electrical issue. Multiple codes coming up but the most common being “circuit B low voltage”. Unsure what it is. Car in limp mode but no odd noises. Rough start but I believe that’s because a sensor on the b circuit is faulting due to the larger issue. It happened after another electrician changed the blower unit for the AC. Was driving fine before then. Fairly confident it's going to be an old wire or connector that has gone but I'm not sure how to find it. I've scanned the obd myself to see many codes including P0238 P0322 P0113 The most common is the sensor reference voltage b circuit p0651 and that one has shown up since beginning. That’s all I know. I’m no electrician so I need a good diagnosis if you can :) Please feel free to ask more questions. Thanks

Needing someone to replace headlights on a Mazda 3. Parts supplied. 2010 model

Hey there, I have a 2003 Mercedes Sprinter and I’m currently experiencing some issues with the van’s electrical system. To keep it brief: fuse #7 (under the steering wheel), which is connected to the air circulation system and the horn, kept blowing. I replaced it, but it continued to blow. At one point, I temporarily installed a higher amp fuse so I could start the van as I was stuck in the middle of the desert. The van did start, but the higher amp fuse eventually burned out as well. Once I got home, I identified the issue: a cable near the horn was exposed and touching the bare metal of the van, causing the fuse to blow. I temporarily fixed it with tape, and replaced the fuse with the correct rating. The van now starts fine, and no fuses are blowing anymore. However, I’m now experiencing the following issues: Some lights are dim (likely need replacing) The horn is not working The radio is not working I’m looking for someone who can properly troubleshoot the root cause and help repair/rework the wiring. Here’s what I’d like help with: Properly insulating and redoing the exposed cables (I currently have a temporary tape fix on 3 wires) Repairing the battery cable terminal (the screw for the negative terminal has broken) Diagnosing and fixing the underlying electrical issue Replacing any faulty lights I need this to pass a Roadworthy Certificate (RWC), as the van is currently registered interstate. I have some basic electrical knowledge and am happy to assist if needed. I can also remove the dashboard beforehand to speed things up and allow you to start troubleshooting right away. I’ve attached some photos for reference. I’m quite flexible with timing, and I’d appreciate a fixed quote if possible, as I’m currently on a budget. Of course, I’ll cover the cost of any replacement parts (like lights) separately. I also use Airtasker, so feel free to reach out there or here if you have any questions. Thanks in advance! Michael

I need a round 7 pin plug with a trailer brake replaced with a 12 pin flat plug fitted with an Anderson plug. I have a couple of other things also. Located at Coorparoo or Park Ridge. Price is negotiable.

Installation of hybrid in a bedroom

2015 Nissan Xtrail ST-L sedan. 2 x HBeam 2 x LBeam 2 x Driving / Fog Lights replacements to LED Status.