Find professional window and door services in Crows Nest NSW

We need some some gyprock to be done following the install of new wardrobes: - our new linen cupboard. This needs to have a shadow gap or be completely flush with the wall. The frame is timber and there is rendering / cement around this. Inside the linen cupboard has exposed bricks which needs to also be covered. - Above / next to the new wardrobes There is also a section to be finished at the top of the new wardrobe with a new matching cornice. No painting required.

I have recently completed a full renovation and repaint of my apartment, however one bedroom door is no longer closing properly. I require a carpenter who can complete the following: * Adjust and repair the bedroom door so that it closes properly. * Install a striker plate. * Repair the chipped edges of the door and repaint the repaired areas. The bedroom door cannot be taken off the hinges due to their age so it does require planing.

Need to open the door and install it on the outside door frame to open outside.

Aluminium stripe and rubber wedge/seal stripe have fell off from the door. 2 aluminium stripes are missing and some rubber seal stripe need to be replaced. See photos attached

The screws holding the rear rollers on the sliding door have pulled out of the door. The same thing has happened previously to the front roller. The problem is the door slides into a cavity in the wall and there is no easy way to remove the door or get good access. About the only way to fix it is to use some wedges underneath the door to take the weight off the roller, an L shaped phillips head screwdriver to tighten up the screws as best as possible and get some epoxy in there using a lollipop stick to glue the roller to the door. So bring some disposable wedges and long setting strong epoxy.

I have a small laundry space that is closed by two bi-fold doors. The track and pivot of the right bi-fold door are damaged and the door doesn't close properly. See the photos for a clearer description. I am looking for a decent fix, the budget is obviously flexible based on needs. Thank you in advance.

Need to repair the bottom piece of the sliding fly screen door. Either with screw or rivot

Fly screen replacement on front security door

Fix the cupboard door as picture shown

My balcony window sliding doors were taken out during a balcony renovation. The sliding fly screen doors were not put back properly and there is a gap at either side. The flyscreen doors are approximately 2.4m tall and 1.7m wide.

Remove one interior (bedroom) door to allow for carpet install. Appears to be fixed pin hinges.

Door handle of one of the bedroom needs to be replaced. I have purchased the new door handle but it is of different size so hole in the door needs to be made bigger.

Door handle of one of the bedroom needs to be replaced. I have purchased the new door handle but it is of different size so hole in the door needs to be made bigger.

I accidentally made a hole in the door, can someone please help me fix this? Thank you!!

Hi I need to replace some old mesh on the door. I don’t have the new mesh but would like to have the aluminium ones. And then put a cat flap on the mesh. Thanks

One of our office doors slams heavily when people are in and out. I believe the strenghth of the door control/ closer needs to be adjusted so there is a few second delayed.

Putting the door back to cupboard

Shower glass/acrylic door frequently comes off track.

6 x towel rails installed into 3 x tiled bathrooms 6 x door hooks installed

I need the weatherproof strip at bottom of rear door replaced.