Find trusted waterproofing contractors in Manly NSW

Bathroom Tiling, Screed & Waterproofing House- Ground Floor - Approx 2.2 x 2.8m 1.9m to two sides of the shower. Rest of the bathroom only 1.5m high tiling 1. Surface Preparation & Screeding • Substrate Prep: Clean and prime the concrete slab to ensure maximum adhesion. • Screed Installation: Supply and install a sand and cement screed bed to the entire floor area • Grading/Falls: Screed must be expertly graded to ensure a consistent fall toward the floor waste and shower waste (minimum 1:60 fall in shower and 1:100 in the general floor area). • Curing: Allow sufficient drying time for the screed before the application of waterproofing membranes. 2. Waterproofing (AS 3740) • Supply and install a certified waterproofing system. Waterproofing to be done x2 - UNDER and OVER screed. • Application: Full floor area (over the new screed and into puddle flanges), shower recesses (to 1.8m), and all wall/floor junctions. • Bond Breakers: Install bond breakers/silicone to all internal corners and transitions. • Compliance: Tiler to provide a Waterproofing Certificate / Form 16 upon completion. 3. Tiling Installation • Floor Tiling: Install Owner-Supplied tiles to the floor. • Shower Walls: Install Owner-Supplied tiles to two (2) shower walls to a height of 1.8m. • Main Walls: Install Owner-Supplied tiles to the remaining bathroom perimeter to a height of 1.2m. • Layout: All tiles to be laid with consistent grout lines (size to be confirmed by Owner). 4. Grouting & Finishing • Grout: Apply grout to all joints (color to be confirmed by Owner). • Silicone: Apply high-quality, mold-resistant silicone to all internal corners, junctions, and base of shower. • Trims: Supply and install aluminum or brass edge trims to all exposed tile edges and doorways. 5. Material Responsibilities by Tiler except Tiles