Hire a trusted stove installation and repair service in Outer East Melbourne

Remove Existing 600 x 500 stove top canopy and replace with pre purchased canopy of same dimensions

stove not turning on. There is spark but no flame. Hot water is working but there is no supply of gas in stove

I need a qualified and experienced tradesperson (stone mason / cabinet maker / benchtop installer) to trim an existing kitchen benchtop so an induction cooktop can be properly fitted. The benchtop is a stone / engineered stone surface (see attached photos). The current cut-out needs to be adjusted. Scope of works: Carefully trim the internal cut-out of the benchtop Each internal corner needs to be cut square to approximately 90° Approximately 20mm needs to be removed from the front internal edge of the cut-out Cut must be neat, precise and suitable for installing an induction cooktop Avoid chipping or cracking the benchtop Final opening must be clean and fit-ready for appliance installation Additional details: Benchtop is already installed Cooktop and cabinetry are in place (see photos) Power is accessible Work is internal and at bench height Please bring appropriate stone cutting tools and dust control Photos: Please refer to the attached photos which clearly show the existing cut-out, corners, and area requiring trimming.

The oven function trips the electricity.

I need an old gas stove decommissioned as we're switching to induction and electric oven.

We need a qualified person to remove our old Neff gas stove top and install a new like for like replacement.

Induction stove installation. Either plug into existing power point or full wiring to metre box. About 6.5 metres. Requires fitting with new bench top cover as existing gas stove is larger. Could be stainless steel. Requires framing as new stove smaller than existing gas stove. Requires gas stove removal and gas capping

Hi there, I need someone to supply and install four new spark igniters on my Valencia gas cooktop (see photo attached – standard ceramic electrode type with white ceramic body and metal tip). Thanks

One of my gas burners on my kitchen stovetop does not light up If it does light up, it turn off straight away

I need a licensed gas plumber to attend and check for a potential gas leak in my stove. -You must be licensed and able to provide a Gas Compliance / Gasfitting Certificate after the inspection. -Please do not make an offer if you cannot provide this certificate. -Task involves inspecting the stove for leaks and ensuring everything is safe.

Swap a elective stove top oven to another electric stove top Removal and Installation of a new steam oven

Can someone please disconnect this as I want to put in tip

Remove two appliances and cap the gas lines

LPG stove and wok burner installation in a food truck. There's a grill; need to replace that with the wok burner and a 4-burner stove.

The new one's gas outlet is on the other side, so extra piping is needed to connect. See photos. Need a licensed plumber who will certify the job.

Need removal of current 54cm freestanding gas stove/oven, then for the new one to be installed by a qualified plumber. Oven not purchased so date is flexible for now. Requires removal of old unit completely (hard rubbish can be discussed).

Door not always closing needs seal replaced at bottom of Emelia gas stove

Replacing a gas stove top with a new induction stove top. The hole needs to be widened in the stone bench to accommodate it.

installation of a new gas stove and remove the old one.

Hi I have an electric cook top that was disconnected for renovations, I want to reconnect it