Find a professional staining service in NSW

Preparing house for sale and looking for an experienced handyman or carpenter or landscaper to repair and refresh the backyard fence and decking Timber fence – approx. 32 linear metres total •Repair/reinforce approximately 10 fence posts/sections as required •Re-nail/resecure loose fence palings •Replace any minor damaged fixings •Clean/prep fence •Scrape/sand rough or loose areas as necessary for painting •Apply 2 coats exterior fence paint •Fence will be painted dark charcoal Timber back deck – approx. 5 m × 4 m (20 m²) in pretty good condition. •Repair/resecure minor loose board (one area only) •Clean and prepare •Sand appropriately for refinishing •Apply 2 coats quality exterior decking stain/oil Please quote for labour. Materials can be supplied by me or purchased by Tasker and reimbursed by agreement. Please bring your own tools and sanding/painting equipment. When making an offer please let me know: 1.Your experience repairing timber fences/sanding and staining decks 2.Whether you recommend spraying or brushing/rolling the fence 3.Whether your quote includes all labour for two coats Priority is a tidy, durable, professional finish for presenting the property for sale, rather than a complete rebuild.

There is an iron burn on one of the bedroom's carpet. Seeking a spot replacement, lets assume 30cm by 30cm. also colour matched. The carpets are due for replacement but I'd like this done prior. Thank you

Wanted: Stainless Steel Flue Pipe & Fittings for Pool Heater Required Items: Flue Pipes (125mm / 5-inch diameter): 3x 4-meter lengths 1x 2-meter length Fittings (to match 125mm / 5-inch flue): 90° elbows (specify quantity needed) 45° bends (specify quantity needed) Material & Construction Requirements: Material: Stainless steel corrosion resistant Seams: Must have welded seams (required for gas heater installation safety). Prefer the above lengths, but if you have another configuration please advise.

Stain wooden entrance door, install hinges and locks and fit door New door measured are exactly the same as existing

Hi, looking for an experienced stonemason to fix my kitchen benchtop. 1. Stain removal: There is a distinct turmeric stain on the surface that needs to be treated/ground down. 2. Scratch repair: There are some small knife marks/points from food preparation that need to be lightly sanded/honed out. I need the area polished to blend in seamlessly with the rest of the benchtop's original finish. Please bring all necessary tools, dust-extraction equipment, and polishing pads. Let me know your experience with this type of stone repair when bidding. Thanks!

Need a hole made in a stainless steel sink. Needs to be 35mm. Quick easy job if someone is interested

Sand decking to blend existing coatings as best as possible and improve the overall appearance. Scrub decking with Intergrain UltraPrep. Pressure wash both decks. Apply 3 coats of Merbau exterior decking oil.

Sand decking to blend existing coatings as best as possible and improve the overall appearance. Scrub decking with Intergrain UltraPrep. Pressure wash both decks. Apply 3 coats of Merbau exterior decking oil.

Our Merbau timber deck needs sanding, staining and sealing for the upcoming summer - we have previously had it sanded back slightly but it is in real need of redoing. Prefer if you arrange for the materials but I can arrange for the sealant / stain to be provided - please clarify on any quote if it is with materials included or not!

I need to wash deck, with aquadeck or cabots deck cleaning and then stain the deck and area. Roughly about a 90-100sqm. Mix of old and new deck. I can supply material or quote inclusive

3 appliances to be welded with brackets to stainless steel in food trailer

Hang 2 small stainless steel shelves, and unscrew picture screws in living room

Looking for a painter to prime with a stain blocking base and repaint a room. Dimensions approx 2.84m by 3.59m, plus the ceiling. One wall has a window which is approx 1.795m wide by 1.47m high. Bring your own tools and products and include all labour and materials in the quote. Prefer not to remove the wall mounted AC. Wall mounted TV either needs safe removal and remount, or paint carefully around it.

Looking for someone experienced to oil/stain our new timber fence in Drummoyne. Fence is approximately 8.6m long × 2.1m high (18m²) * I will supply the timber oil * You supply brushes/rollers and all other equipment * Protect surrounding artificial grass, paving, walls and garden from drips/splashes * Leave the area clean and tidy afterwards Only the one visible side of the fence shown in the photo needs to be done. Looking for someone with experience.

Small section of timber flooring needs to be installed. This will include purchasing floorboards, install them and staining them ensuring they match the existing flooring. Subfloor may also need to be replaced. Happy to negotiate price pending scope

Sand & stain 15 x 4 metre deck

Stain a retaining wall for an outdoor yard Approx 15m x 1m - photos show the detail Stain tub provided (4L) as well as 2 microfibre brushes

Approx. 27 m long × 2.5 m high (approx. 67.5 m²), one visible side. Scope: • Thoroughly clean and prepare timber • Sand weathered/rough areas and provide an even finish • Apply two coats of supplied exterior Merbau timber stain/oil, following manufacturer instructions • Protect paving, plants, pool glass and adjacent surfaces from dust/stain • Include all labour, drop sheets, masking and cleanup etc Materials and equipment supplied including hand sander, stain and applicator. Please quote based on experience with Merbau/timber screening and advise estimated duration. Photos attached.

We've recently moved into a house where one section of wooden floorboards is coloured differently to the nearby sections. We would like that section of floor restained so that it better matches the rest of the house. We know it likely won't be possibly to perfectly match the colour - that's fine, we just want the difference to be less obvious. The area measures approximately 3.5m x 3.5m. We don't know what wood the floorboards are made of, nor what stains or products have been used. The house is from around 1900. We are seeking someone to: - Sand that area of floor back, - Stain the floorboards to better match the rest of the house, and - Apply a new topcoat. We will pay for the stain and top coat - but would appreciate your expertise to choose and purchase the right products to use, particularly to best match the colour. The house is currently empty so there's no furniture etc to work around. We will have some people painting the house at the same time but will make sure they are not in your way. Work can be carried out any time between Sat 15 Aug to Thu 20 Aug. There's free street parking outside and it's usually not difficult to find a spot. We're just off Princes Highway, near Tempe and Sydenham stations. Feel free to ask any questions.

I need a painter to touch up and repaint my balcony ceiling. There are a few water stain lines from an old gutter leak (gutter is already fixed). New added: Sand and apply varnish to the wooden front door. I have the varnish ready