Find a professional sauna installation service in North West Melbourne

Electrical cable sauna installation & install of camera

Sunlighten sauna dismantled at a pascoevale pilates studio. Then re assembled at our house in kinglake west. Will need a trailer or van to transport. I have a detailed video of how to dismantle and assemble. Will need two people to move

POWER REQUIREMENTS 220–240V, 2695 watts. Maximum Amperage 12A. Sunlighten recommends all new installations adhere to AS3000 and a dedicated circuit that is RCD protected, along with a readily accessible switch. A 2.5m cord exists with a 15amp male plug, exiting back left of base.

Hello, ​I require a fully licensed and insured electrician to inspect and repair an electrical fault on my plug-in infrared sauna located in my garage. ​The Problem: ​The primary power cord on the sauna became visibly frayed/damaged. ​Following the cord damage, the household fuse/circuit breaker for that outlet tripped/blew. ​The Task: ​Isolate and Inspect: Safely test the circuit and the sauna to confirm the fault. ​Cord Replacement: Supply and install a new, correctly rated power cord, replacing the damaged section right up to the sauna's internal connection point (terminal block). ​Fuse Box Reset/Check: Inspect the tripped circuit breaker/fuse to ensure no further damage occurred. ​Requirements: ​Must be a fully licensed and qualified electrician in Australia. ​Note: The sauna is currently unplugged, and the circuit breaker remains off for safety. Please DO NOT attempt to plug it in before inspection. **open to any offers. Just put in a random price to begin with. Cheers

I need someone to meet my team at our warehouse in Coburg north at 7am, it will be a full days work finishing at around 3pm. You will be in the van with an experienced installer just assisting them with the assembly of flat packed saunas.

We have a leaking sauna roof. Ideally after a roofer/roof plumber or chippy/carpenter to make and install a color bond roof? Open to suggestions. Currently has bitumen roof shingles but not cutting it. I have include photos of what I want it to look like.

Need help setting up new Sauna Vikara epoch 2 person, needs to be done on Friday. Getting delivered around 9am. Can send the manual instructions. Looking for quotes.

Due to the high power requirements of this unit (8kw), it requires a dedicated circuit with a minimum 40A breaker for safe and reliable operation. This unit must be hardwired by a licensed electrician to meet electrical safety requirements. For installation end of June

Assembling of sauna https://www.luxoliving.com.au/tarni-2-person-traditional-finnish-outdoor-sauna From the 23rd of June onwards flexible on time If you know electrician that would be good please quote for that thank you

Install an infrared sauna

Need a sauna picked up in dissembled from Mickleham and delivered to waterways and will need it assembled again please. “will just need to deassemble it with an electric screw driver my ex can show them when they get there takes 2 seconds and then it can be flat packed and reassembled same way there is just a few screws and then it all clips together”

Purchased from alpine spas. Has full instruction manual. Can be done solo but second person will be handy.

Just need someone to build my sauna pod today cheers!

Im looking at upgrading my sterilising set up which heats Mushroom Substrate Blocks up to 95deg (currently run a boiler into oil drums). This new set up creates a small room which i can wheel a shelf into. The set up can be seen in the pictures below. This will be built in a small warehouse and ideally can be relocated incase we move warehouses. Im assuming it can be constructed using fridge panels? The room would be approx 2m x 2m x 0.6m so ive calculated roughly 13m2 needed of fridge panels - Due date: Flexible