Find a professional render contractor in North Brisbane

There is one existing visible weep hole that can be used as a guide for the correct height and spacing. I need someone to: • locate the remaining original weep holes around the house all 4 sides. • carefully grind or chisel the render to expose them. • make sure they are open and clear. This is not structural work just careful render removal around existing weep holes. House is single storey with concrete paths and driveway around the base.

Retaining wall rendering. Approximately 35m2. Easy access.

Render repair and painting

Required rendering of under Windows approx, 120mm wide and 16m in length. Along with a small area around stairs.

Rendering the brick holes There are holes in between the bricks that need a good fix.

need four fence posts to be rendered on extended half front and back only. The posts is already cemented and need thin layer of render over that part

Peeling rendered brick internal wall

Need someone to patch and paint render at Wavell heights asap. Please put in offers

Ok, so I attempted to render an old brick wall. It didn’t go well. I’m aware I made it worse. So now I’d like it done please. I sucked 🤦🏻‍♀️ It’s the wall in the photo and then around a small corner. I’ll get better photos later, just need to know if I can afford it and how quickly someone could do it. I just put a random price as I have no clue what’s fair.

Minor render repair of block wall. No need to repaint

Fix front rendered fence where bits of render are falling off and repaint entire yellow fence to match repair job Sand back and rePaint wooden sections of front fence fix pool render and repaint

Hi! We’re looking for a reliable renderer to help us with a few sections of our house that still need rendering (see photos attached), patching and finishing the remaining areas. We’re after someone experienced who can match the existing render and give it a smooth, professional finish. Please send me quote.

I would like to remove the joint lines on the front of my house to give it a rendered finished look to it. can anyone give me a rough quote on how much am I looking at to do something like this.

Rendering of two walls. Easy acsess Wall one: 2200x1230 Wall two: 1700x1230

Need to top coat or fix the existing brick fencing rendering with another layer of render to smoothen/flatten the current finish that was poorly done as a DIY job. Looking for someone experienced in cement/render/ to do the job. There are 6 sections, 7 brick pillars to be done in total. Come inspect the site if you want to properly estimate the job.

Filling the cracks in the fence's surface to create a smooth, finished appearance before painting.There are 6 posts.

I'm looking for a reliable and experienced handyman or renderer to carry out some minor patch rendering and painting on the exterior of my property. A few areas of the facade have been damaged (e.g., cracks, chips, weathering) and need to be repaired and repainted to match the existing finish. Job Details: - Approx. number of patches: 5 Small Areas - Type of damage: Small Areas where Surface has been chipped Surface & Damaged. - Surface type: Hebel & Concrete

A short wall about 450mm high, 16.5m long. Looking for a single coat of acrylic render 3-4mm thick with angle beads on the corners. Sponge finish.

Render up to 10mm in render ardex wr120 ready for tiler

Looking for someone to render and paint existing wall