Book a trusted oven repair and installation expert in Baulkham Hills & Hawkesbury

When the oven door is open, the flame ignites and stays on. As soon as I close the oven door, the flame goes out very quickly. Which may due to : The flame safety device/thermocouple may not be maintaining the gas supply properly, or there may be an issue with the burner’s air intake or ventilation. When the oven door is closed, the flame becomes unstable and goes out. Or other issues . Westinghouse model: WVG655SCNG

I think the thermostat on my oven isn't working and it just keeps getting hotter

Need a small drawer over the oven in the available space..Please see attached photos.

Fisher and paykle appliance . One of the burner is not working . Fisher and paykle the oven is not working

Installing of new 60cm wall oven including wiring of plug base

The oven is an ILVE, 9 years old, it turns on by itself and heats up; can't turn it off because it is OFF; so I turn it off from the fuse box

Fixing my oven that is only 5 years old

The oven switch on my electrical switchboard will not stay in the ON position. It keeps returning to OFF and the oven cannot be powered on. Looking for a licensed electrician to inspect the switch/circuit, identify the issue and repair or replace the faulty component as required. Please provide a quote including parts and labour.

Our Oven's door does not close in full. Fisher and Paykal, 600mm. The issue might be from the hinge. I have attached photos.

Require supply and replacement of shower tap washer Repair of oven door

My existing oven is hardwired. I'd like a 15A outlet for the new oven and a standard 10A outlet for the gas cooktop installed inside the same adjacent kitchen cabinet, provided it complies with Australian standards and there is sufficient space.

While I was cooking the boiling water fell

While I was cooking the water was boiling and the cook top was clean then the oven turned off no water in the oven

Smeg freestanding dual fuel oven needs repair

I need an old electric oven disconnected and a new one installed.

Need to replace 60cm induction cooktop and oven underneath. I have ordered new ones. Need electrian to install both.

I am replacing an old all-in-one electric stove with a separate ceramic cooktop and under-bench oven. There is an existing stove connection cable available in the kitchen, which I believe is connected to a 40 amp stove circuit. The new appliances are: 60 cm ceramic cooktop, approximately 6,000 W / 25 A, hardwired Under-bench oven with a standard 10 A plug

I need my existing kitchen oven housing cabinet increased by 10cm. I have an existing 90cm x 50cm x 57 oven which is being replaced with a new one that is 90x 57 x 57 so I need the housing adjusted. There is a 20cm drawer below so this can be used (10cm) to increase the housing to fit the new oven in. Therefore need sufficient skills to increase size using this drawer space including making the remaining 10cm gap good - probably by using the existing drawer cover and cutting in half and fitting (ie no long a drawer as it isn’t used anyway).

Supply and install heating element in my oven. It is behind the fan at the back of the oven. Less than five years old. DEVANTI 70L Electric Oven Built in Wall Forced Grill Stainless Steel Convection Size: OSFA SKU: 746927290 Serial No. 20200430066 Power 200W SGS90246-EA

The door came off my built-in Omega oven. The hinge mechanism appears intact but the door frame coating has deteriorated. Need someone to assess and reattach the door if possible, or advise on next steps. Photos available.